Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Figure 4
Follow the throttle wire from the handlebars to
locate the white plastic connector to the control
module. Disconnect by depressing the tab. Cut the
zip tie and remove the cable wrap. Note: Save the
cable wrap for reassembly. Gently pull the throttle
cable through the hole in the number plate.
Step 4
Figure 5 Figure 6
Using a 2.5mm Allen wrench, loosen the throttle
set screw, but do not remove and move throttle
away from the grip.
Carefully wedge the flat head screwdriver under
the edge of the handlebar grip add a small
amount of lubricant or water and remove the
grip. Note: Save the grip for reassembly
Step 5 Step 6
Step 7
Reverse steps:
1. Place the new throttle on handlebar and secure, cleaning the grip of any water or lubricant and reinstall.
2. Reconnect the white plastic throttle connector to that of the control module.
3. Reattach battery cover using the same eight screws previously removed.
4. Replace the fairing and refasten the screws.
ATTENTION: Charge unit at least 18 hours before riding.
Figure 3
Remove the eight Phillip screws that hold the
battery cover.
Step 3
BOTTOM VIEW
SIDE VIEW
130710
