rba Raffaello 90 LH RBA4601-171 Manual

INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY |MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
4
13. Position ange cover so
the hole is over the screw
xing point. Secure the rst
screw.
11. Ensure rail is level10. Ensure snug t.
14. Rotate the ange cover
so the hole is positioned over
a new screw xing point.
15. Push ange cover over
wall plate and insert ange
button.
12. Mark location to install.
16. Place screw into screw
cover before securing rail
bracket
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY |MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
1
RBA Modular Rails
RBA4601-171 Raffaello 90° LH Accessible Grab Rail | White
RBA4601-178 Raffaello 90° LH Accessible Grab Rail | Matte Black
RBA4601-179 Raffaello 90° LH Accessible Grab Rail | Chrome
RBA4601-181 Raffaello 90° RH Accessible Grab Rail | White
RBA4601-188 Raffaello 90° RH Accessible Grab Rail | Matte Black
RBA4601-189 Raffaello 90° RH Accessible Grab Rail | Chrome
Sourced/ Supplied under QMS
Date 27/10/20
Model
RBA Modular Rails
Supercedes all previous
ii/rba4601-17&18
Series/1020

INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY |MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
2
YOU ARE RESPONSIBLE FOR THE SAFE OPERATION OF THIS UNIT
Attention
For optimum installation use at least 4 suitable screws for each wall-plate. Screws should be
selected to suit the wall type.
Grab Rails are no stronger than the anchors or walls to which they are attached, and therefore,
must be rmly secured in order to support the loads for which they are intended.
Maintenance and cleaning instructions
Do not use detergents containing bleach, acids, alkalis, or chlorine or abrasive products. Do not
use abrasive objects (e.g. scouring pads). Do not use chemicals that can damage plastic. Clean
the surface with water and a neutral detergent; rinse carefully and dry with a clean cloth. If
alternative cleaning methods and/or chemicals are used, warranty may become void.
Important Warnings
Exceeding the maximum load values may cause permanent product damage. If this happens,
cease use until checked by a specialised maintenance person. Improper use, such as for
gymnastic exercises or as a step, may cause accidents with serious consequences. Reliable
operation and product safety depend on the way the products are installed and used.
Ensure installation is performed by qualied personnel. Incorrect installation can seriously
compromise product functionality.
Tools Required
Plumbers Tape
Screw Driver
Extended Driver Bit
Spirit Level
Components Supplied
2x Flange Cover
2x Bracket Post 2x Bolt 8x Screw 8x Wall Plug
1x Horizontal Rail 1x Vertical Rail 1x Rail Bracket
2x Wall Plate 2x Flange Button
2x Screw Cover1x Rail Connector
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY |MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
3
7. Repeat for other xing
points.
1. Lay rail at with thread
facing up.
9. Connect rails.
2. Place bracket post onto
rail.
3. Slide ange cover over
post.
4. Insert bolt through wall
plate.
5. Insert wall plate and bolt
assembly
6. Tighten.
8. Screw rail bracket into
threaded insert