STANDARD 555 Kit Wireless
User’s Manual
Technical support: www.real-el.com
3
ENG
CONNECTION
•Connect the 2.4 GHz USB nano receiver (Fig. 2) to a free USB port of your PC.
• Turn your PC. To activate the set, press any button of the mouse or turn the scroll wheel. If the
connection is correct, the set will turn on automatically.
• After finishing your work, you can pull out the receiver from the PC USB port and insert it into the
mouse as shown in Fig. 4.
• If the mouse or keyboard don’t work, connect them to the nano receiver again. To reconnect the
mouse to the nano receiver, press its right button and the scroll wheel at the same time and, while
holding them, pull out and insert the 2.4 GHz nano receiver back into the USB port. To reconnect the
keyboard to the nano receiver, press its «Esc» и«K» buttons at the same time and, while holding
them, pull out and insert the 2.4 GHz nano receiver back into the USB port.
Notes:
• Do not place the receiver into a confined metal space (table drawer, box, safe), as a me-
tal screen does not transmit radio signals.
• If batteries run down, there are «lapses» in operation of the mouse or keyboard. In such a
case replace the batteries with new ones.
• If there is a long pause in operation of the mouse or keyboard, they enter the Sleep mode.
To enter the working mode just press any button.
Problem
The keyboard and mouse
are not working.
Solution
1. Check whether the batteries have been installed correctly. If ne-
cessary, replace the batteries with new ones matching the polarity.
2. Pull out the USB nano receiver and insert it back, make sure that
it is not damaged.
3. Reprogram the USB nano receiver using the software you can
download at www.real-el.com
4. We recommend that you address your nearest service center.
If none of the above methods can solve the problem, please seek professional advice at your nearest
service center. Never attempt to repair the product yourself.
TROUBLESHOOTING