RECREUS EXTRUDER V3 User manual

RECREUS
EXTRUDER V3

PACKING
LIST

STEP 1: MOUNT IDLER ARM STEP 2: INSERT BEARINGS AND MOTOR
ASSEMBLE EXTRUDER
BLOCK TO STEPPER MOTOR.
STEP 3:
INSERT AND TIGHTEN DRIVE GEAR.
STEP 4:
INSERT AND TIGHTEN 100k THERMISTOR.
STEP 5:
INSERT AND TIGHTEN HEATER CARTRIDGE
STEP 6:
INSERT AND TIGHTEN HOTEND.
STEP 7
INSTALL 25X25 COOLING FAN
STEP 8:

TIGHTEN THUMB SCREW WITH RUBBER
REGULATOR
PROVIDED UNIVERSAL EXTRUDER MOUNT, THAT ALLOWS TO INSTALL IN ALMOST ANY
3D PRINTER WITHOUT TOO MUCH MODIFICATIONS
STEP 9:
MOUNTING OPTIONS
PRUSA STYLE PRINTERS
TOP STYLE EXTRUDER PRINTERS

CONFIGURATION
STEPS/REV,
Set up the following steps per revolution in your firmware (marlin, repetier, sailfish etc)
E0 (EXTRUDER)
-137 steps/rev (1.8º- 16 Microstepping)
-274 step/rev (0.9º-16 Microstepping)
-274 steps/rev (1.8º 32 Microstepping)
-548 steps/rev (0.9º 32 Microstepping)
THERMISTOR TYPE
Set up the following thermistor type in your firmware (marlin, repetier, sailfish etc)
-Type 0: EPCOS 100K Thermistor