Everest GEN7
Insert the BIND PLUG into the receiver BIND
port.
Make sure your ESC is plugged into CH2,
and insert the bind plug into BIND/VCC.
Now, power the vehicle on and the receiver
light should begin to blink red.
Press the BIND button in the center of the Press the BIND button in the center of the
transmitter’s Control Panel and turn on radio.
Release the bind button when you see the
Release the bind button when you see the
green light on the radio flashing. At this
point, your receiver's LED light should pause
for approximately 1 second and then blink
slowly. Turn off the power to your vehicle, as
well as the radio.
Remove the BIND PLUG from the receiver. Remove the BIND PLUG from the receiver.
Make sure the servos and ESC are attached
as described above.
First turn your radio on, then your vehicle as
normal. Your radio and receiver should be
bound together and communicating with
each other.
1.
2.
3.
4.
5.
6.
CONTROL PANEL
BIND PLUG
BIND/VCC
CH3
ESC
STEERING
RECEIVER
FAILSAFE
TRANSMITTER
ANTENNA
CONTROL
PANEL
STEERING
WHEEL
THROTTLE
TRIGGER
New high clearance
steering knuckles,
included with this kit,
included with this kit,
require the “Steering
Dual Rate” knob to
be set as shown. A
higher setting may
damage the servo.
!
ATTENTION
RADIO GUIDE
