Regalo FLEXI GATE FORM 1175 User manual

FLEXI GATE form
MODEL NO:1175/1180
Owner’s Manual
READ ALL INSTRUCTIONS BEFORE ASSMBLY AND
USE OF GATE. KEEP INSTRUCTIONS FOR FUTURE USE.
Regalo International, LLC.
14305 Southcross Drive, Suite 100,
Burnsville, MN 55306
Phone: [phone]
FAX: [phone]

Flexi Gate from
ADDITIONAL EXTENSIONS SOLD SEPARATELY!
WARNING:
Intended for young children aged six months through 24 months.
Check the gate regularly to see if all the hardware and mountings
are tight.
To prevent serious injury or death, securely install gate or
enclosure and use according to manufacturer’s instructions.
Never use with a child able to climb over or dislodge the gate or
enclosure.
Never leave child unattended.
Use only with the locking/latching mechanism securely engaged.
To prevent falls,NEVER used at the top of stairs.
Contact Regalo for questions and replacement parts. If in doubt
about the use of your gate, call our customer care line 952-435-1080.
Regalo International, LLC.14305 Southcross Drive,Suite 100,
Burnsville, MN 55306.Made in China
Assembly and Installation Instructions
Please read these instructions carefully before installing
your gate.
Important: There are four pieces of Wall Mounting
Hinges. These Wall Mounting Hinges must be used in
securing your gate to the wall . If not, the gate can
become dislodged from the opening and unstable.
(1)

Check to make sure you have the following components
before you begin to set up your gate.
(1). Folded Gate Frame, and Wall Mounting Assembly
(2). Mounting Screws x 8 pcs.
(1) 1 pc (2) 8 pcs
(2)

Step 1. Preparing to Install your Gate
Begin by unfolding the gate frame. To do this simply
loosen the Locking Knobs at each pivoting joint by
turning the knob counter clockwise as shown in
Diagram 1. Loosen the knobs enough to allow the gate
to swing open freely.
Diagram 1
(3)

Step2: Move the gate to the side of the wall opening
then bring the Wall Mounting Hinge to the wall as
shown in Diagram 2.
Diagram 2
(4)

Diagram 3
Step 3: Apply a screw driver to fix the Wall Mounting
Hinge on to the wall as shown in Diagram 3.
(5)
Step 4: Repeat the Step 2 and 3, on the other end of the
gate. Go back an tighten all Locking Knobs. When this
is done, the gate is ready to use on the gate opening.