Rehab and Mobility Products RM159 Programming manual

Pedal Exerciser with Digital Display
RM159
Usage and Maintenance Instructions

INTRODUCTION
thank you for deciding to purchase the Pedal Exerciser from Rehab and
Mobility. The Pedal Exerciser is manufactured from the finiest materials and
components available, when used correctly it is designed to give years of
trouble-free service.
BEFORE USE
Carefully remove all packaging. Avoid using any Knives or other sharp
instruments as this may damage the surface of the product
Check the product for any visible damage, If you see any damage or suspect a
fault, do not use your product and contact your supplier for support.
INTENDED USE
The pedal exerciser enables both upper and lower body exercise from a seated
position, pedals can be moved forward or backwards and the resistance can be
adjusted with the top adjustment knob.
1. Unfold the legs until the Locking Pins click (See fig.1 below
Resistance
Adjustment
Locking
Pin
Locking
Pin Ring

2. For lower body exercise position the Pedal Exerciser on the floor and slip
your feet into the looped pedal straps. Rotate the pedals forwards or
backwards as desired.
3.
The resistance can be adjusted using the knob on the top of the unit.
4.
Requires no external power supply.
5. The unit folds away for easy storage. To do so pull the locking pin ring (see
fig 1) to release the leg and fold away underneath. Repeat for the
remaining leg.
Stopped Indicator
Fig.2
■
-
CNT
Rotation Count
Indicators
Selector Button Indicated Display
Digital Display
To turn the display on press the orange button. The display shows the rotation
count and the side indicators show what the Indicated display is currently showing.
The display can show the following;
TIME : Time in Use
RPM : Revolutions Per Minute
CAL: Calories Used
SCAN : Rotates through the indicated displays pausing for Ss on each
To reset the display press and hold the orange button for 4s till display shows all
zero's.
If the unit is not used for 4s the STOP indicator come on and the timer will stop. If
the unit is unused for approx. 2 minutes the display will turn off.
Al
RPM

CLEANING
Clean your Pedal Exerciser using a non-abrasive cleaner or mild detergent with a soft
cloth. Abrasive cleaners and/ or abrasive cleaning pads may seriously damage the product
beyond repair and should not be used. Always ensure that you wipe dry the equipment
after cleaning.
REISSUE
If you reissue or are about to reissue this product, please thoroughly check all
components for their safety.
This includes:
• Tightness of all nuts/bolts/castors
• Other screw in/bolt in/push in components.
If in any doubt, please do not issue or use, but immediately contact your supplier for
service support.
CARE & MAINTENANCE
Please make a safety check of the product at regular intervals or if you have any concerns.
IMPORTANT INFORMATION
The information given in this instruction booklet must not be taken as forming part of or
establishing any contractual or other commitment by Rehab and Mobility Wholesale or its
agents or its subsidiaries and no warranty or representation concerning the information is
given.
Please exercise common sense and do not take any unnecessary risks when using this
product; as the user you must accept liability for safety when using the product.
Please do not hesitate to contact the person who issued this product to you or the
manufacturer (detailed below) if you have any queries concerning the assembly/use of
your product.
Rehab and Mobility Wholesalers, PO Box 1039 Burpengary Qld 4505 Telephone:
1300 368 085
• Fax [phone] •
Web: www.rehabandmobility.com.au Email:
[e-mail]

NOTES: