Remaco PLT-418C User manual

Model Kept Position Maximum Extended Position
PLT-418C A = 71cm to 94cm A = 448cm to 471cm
38.0cm
Red Knob
(upper limit)
White Knob
(lower limit)
+-
+-
Step 4
Frame
52.0cm
78.0cm
60.0cm
86.0cm
78.0cm
52.0cm
3.0cm
3.0cm
A
* Put the projector here
Warning Caution with main supply and live wires. Install with qualified technician or trained
personnel.
Installation Guide (PLT-418C)
CWebsite: www.remacotech.com
COPYRIGHTS 1998 REMACO TECHNOLOGIES PTE LTD
PLT
V: 10.3
Steps for Installation
A) Drill Dia. 10mm holes to a depth of 35mm.
(Note: Do not drill too deep)
B) Insert M8 anchor into the hole.
C) Use pin punch to expand the anchor.
Hammer
Pin Punch
M8 Anchor
10mm Drill
Power Drill
35
AVA-200
Wall Switch
D) Connection of all cables to the MPC-851
(Refer to Installation Guide for MPC-851)
MPC-851
Motor Power Control
AVA-210A
Sensor
AVA-301
2-Channel
Infrared Remote
Projector
Projector Lift
STOP UP
DOWN
Step 1
Step 2
Step 3
AVA-316
15-Channel
RF Remote
Do not adjust the Upper Limit of the lift higher than the original factory preset position. If adjusted, the lift will move into the frame and be stopped by force and not the Upper
Limit Switch. This will cause overheating of the motor, rendering the lift to being unable to operate properly.
Important Note
Upper Limit (no need adjust unless required)
Press “UP button” and adjust motor upper limit “ - “ (lift move away
from the frame) Then adjust upper limit “ + “ and let the lift move
more into the frame until reaches maximum height (scissor bars just
about fully close)
Lower Limit
Press “Down button” and adjust motor lower limit “-“ to have
less drop first. Adjust lower limit “+” to let lift have more drop
to required height.
Bottom View
(Motor)
Alen Key Adjusting Tool
(to set knob limit switch)
Important Note
All connections
are to the MPC
MPC-851
Motor Power Control
For connection details,
please refer to the
Installation Guide
provided
Connect
to the MPC

End
False Ceiling Support
M6 Threaded Rod
M6 Washer & Nut
Option 1
False Ceiling (Tile Ceiling Board)
M6 Threaded Rod
M6 Washer & Nut
Option 2
False Ceiling (Plastor Fiber Ceiling)Partition Screws
Wood or Board
(Not provided)
Simple Method to insert false ceiling
Lay false ceiling board 45 degree on false ceiling
frame as shown.
Rotate and false ceiling board will position correctly.