Remaco PLT-415 User manual

8.0cm
4.50cm
Adjustable
16cm
to
210cm
12 x 4 Nos.
55.0cm
45.5cm
8.00cm
Ceiling Suspension
Ceiling Mount
FrontBack
FrontBack
55.0cm
29.0 cm
Adjustable
20-32cm
50.8cm
50.8cm
60.0cm
60.0cm
Warning Caution with main supply and live wires. Install with qualified technician or trained
personnel.
Installation Guide (PLT-415)
CWebsite: www.remacotech.com
COPYRIGHTS 1998 REMACO TECHNOLOGIES PTE LTD
Types of Installation Mount
PLT
V: 4.4
Steps for Installation
Alen Key Adjusting Tool
(to set knob limit switch)
Bottom View
(Motor)
White Knob
(lower limit)
Yellow Knob
(upper limit)
+-
+-
Do not adjust the Upper Limit of the lift higher than the original factory preset position. If adjusted, the lift will move into the frame and be stopped by force and not the Upper
Limit Switch. This will cause overheating of the motor, rendering the lift to being unable to operate properly.
Step 4
Important Note
Frame Upper Limit (no need adjust unless required)
Press “UP button” and adjust motor upper limit “ - “ (lift move away
from the frame) Then adjust upper limit “ + “ and let the lift move
more into the frame until reaches maximum height (scissor bars just
about fully close)
Lower Limit
Press “Down button” and adjust motor lower limit “-“ to have
less drop first. Adjust lower limit “+” to let lift have more drop
to required height.
A) Drill Dia. 10mm holes to a depth of 35mm.
(Note: Do not drill too deep)
B) Insert M8 anchor into the hole.
C) Use pin punch to expand the anchor.
Hammer
Pin Punch
M8 Anchor
10mm Drill
Power Drill
35
AVA-200
Wall Switch
D) Connection of all cables to the MPC-851
(Refer to Installation Guide for MPC-851)
MPC-851
Motor Power Control
AVA-210A
Sensor
AVA-301
2-Channel
Infrared Remote
Projector
Projector Lift
STOP UP
DOWN
Step 1
Step 2
Step 3
AVA-316
15-Channel
RF Remote
M8 Threaded
(Optional)
Important Note
All connections
are to the MPC
MPC-851
Motor Power Control
For connection details,
please refer to the
Installation Guide
provided
Connect
to the MPC

To be
mounted onto
PLT Base
Pan/tilt
swivel
Important Notes:
All spider brackets are thoroughly inspected and fully
tested operational in factory. We accept no liability
whatsoever for any losses due to improper operation,
or any unauthorized alternation. All trademarks contained
in this installation guide are the property of their respective owners.
Projector Spider Bracket
End
False Ceiling Support
Option 1
Option 2
False Ceiling (Plaster Fiber Ceiling)Partition Screws
Wood or Board
(Not provided)
M6 Threaded Rod
M6 Washer & Nut
False Ceiling (Tile Ceiling Board)