Remii Amantii CLASSIC SLIM 33 Assembly instructions

CLASSIC SLIM –Repair Guide
09.26.21

Content
•Replacing the LED light(flame and tray light)
•Replacing the flicker motor
•Replacing the circuit board
•Replacing the heating element
•Replacing the touch panel
•Replacing the signal receiver and WiFi card

STEP 1 Remove the magnetic stone to remove the
horizontal hardware trim
Screws are visible after the trim has been removed
Remove the horizontal hardware trim .
The horizontal hardware
trim is situated here
The horizontal hardware trim
Screws are situated here
Replacing the LED light
FLAME LIGHT

STEP 2
Remove the two (2) screws to remove
the front glass steel bar and the front
glass panel
The screw The screw
The steel bar

STEP 3 Remove the four (4) screws to remove the back glass fixing
steel bars and remove the back and tray glass

It should now look like this once the back and tray glass are removed.

Remove the four (4) screws to disconnect the flame stencil from the
fireplace.
STEP 4

Unplug the LED strip from the fireplace to remove the flame stencil and
flame LED light assembly from the fireplace.
STEP 5

You can replace the flame display LED strip.

Replacing the tray light
Remove two (2) screws to disconnect the tray light assembly from the fireplace.
STEP 6
Please follow steps 1 through 5 from replacing the flame light.

Unplug the tray light from the fireplace and
detach the wiring from the slot to take off
the tray light assembly.
Slot
Wiring
STEP 7

If you cannot remove the wiring out from the slot, loosen the adjustable
foot slightly to remove the wiring out from the slot and take the tray light
assembly off.
Adjustable foot
STEP 8

Unscrew the screw Disconnect the flick
rod from the motor
Remove two (2)
screws to disconnect
the motor from the
fireplace
Replacing the flicker motor for the flame
Please follow steps 1 through 5 from replacing the flame light.
STEP 9

Remove the two (2) screws to take off
the circuit board protective panel
Unplug and replace a new motor
STEP 10

Remove the two (2) screws to take off
the circuit board protective panel
Remove the four (4) screws and
unplug to insert a new circuit board
STEP 11
Replacing the Circuit Board
Please follow steps 1 thru 3 in replacing the flame light.

Unscrew the four (4) large silver colored screws and two (2) black screws to
disconnect the heat assembly from the fireplace.
STEP 12
Replacing the Heating Element
Please follow steps 1 through 3 from replacing the flame light.

Remove four(4) screws and unplug to replace a new heater.
STEP 13

Unscrew two (2) screws to disconnect the touch panel assembly from the
fireplace.
STEP 14
Please follow steps 1 to 3 in replacing the flame light.
Replacing the Touch Panel

Remove two (2 ) screws and unplug to replace a new touch panel
Unplug
STEP 15

WiFi Card
Signal receiver
Replacing the Signal Receiver and WiFi Card
Please follow steps 1 through 5 in replacing the flame light.