Remington X6 POWER-X Series User manual

X6 Power-X Series Hair Clipper
HC6000
I remington-europe.com
Register online for an EXTRA year guarantee
Visit uk.remington-europe.com/product-registration You must register within 28 days of purchase.

s
e
m
j
k
ig
f
n
o
r
l
h
h
AB

3
Thank you for buying your new Remington® product. Please read these instructions
carefully and keep them safe. Remove all packaging before use.
IMPORTANT SAFEGUARDS
• This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they are
older than 8 and supervised. Keep the appliance and cable out of reach of
children under 8 years.
The device is suitable for cleaning under an open water tap.
• WARNING: Detach the device from the charging adapter before cleaning it in
water.
• Do not use the product with a damaged cord. A replacement can be obtained
via our International Service Centres.
• WARNING: For recharging the battery, only use the charger supplied with the
appliance - type reference PA-0510U.
• The adaptor contains a transformer. Do not cut o the adaptor to replace it with
another plug, as this causes a hazardous situation.
• Use this appliance only for its intended use as described in this manual. Do not use
attachments not recommended by Remington.
• Do not use this product if it is not working correctly, if it has been dropped or
damaged, or dropped in water.
• This appliance should never be left unattended when plugged into a power outlet,
except when charging.
• Keep the power plug and cord away from heated surfaces.
• Do not plug or unplug the appliance with wet hands.
• Do not twist or kink the cable, or wrap it round the appliance.
• This appliance is not intended for commercial or salon use.

4
PARTS
1. Blade set
2. On/O/Turbo Switch
3. Length adjustment dial
4. Length setting window for 25 - 35 mm
comb
5. Length setting window for 14 - 24 mm
comb
6. Length setting window for 3 - 13 mm
comb
7. Digital display
8. Charger connector
9. 25 - 35 mm comb
10. 14 - 24 mm comb
11. 3 - 13 mm comb
12. Micro fade adjustable comb
Not Shown:
• Adaptor
• Cleaning brush
• Oil bottle
GETTING STARTED
CHARGING YOUR APPLIANCE
• Before using your hairclipper for the rst time, charge for 1 hour.
• Ensure the product is switched o.
• Connect the charging adaptor to the product and then to the mains.
• If the product is not going to be used for an extended period of time (2 – 3 months),
unplug it from the mains and store.
• Fully recharge your hairclipper when you would like to use it again.
• Allow 1 hour for a complete charge.
DIGITAL DISPLAY
• The device features a digital fuel gauge to show remaining charge and charging status:
During charging:
When the unit is plugged in, the corded indicator icon will
show ( ). With the device turned o and connected to the
charger, the display will light up in a rotating pattern during
charging.
Once charged the display will show 90 and the corded
indicator icon ( ).

5
During corded use:
When the unit is plugged in, the corded indicator icon will
show ( ). Normal operating speed:
When the unit is plugged in, the corded indicator icon will
show ( ). Turbo mode:
During cordedless use:
The display will show the remaining run time in minutes.
When the run time reaches 5 minutes it will ash.
When in turbo mode, the display will be the same as above
with the turbo symbols (>>>)
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 1 hour.
• The clipper comes with a quick charge function, 10 minutes charging will give an
emergency burst of run time.
CHARGING VIA STANDARD ELECTRICAL SOCKET
• Ensure the product is switched o.
• Connect the charging adaptor to the product and then to the mains.
USB
• Connect Micro USB to the appliance, and the USB connector to any standard USB port
or charger
• Product will only charge through USB and will not run in corded mode.
CORDED USE
• Connect the charging adaptor to the product then to the mains.
CAUTION Extended mains only use will result in the reduction of the battery life.
CORDLESS USE
• When the product is switched on and fully charged it can be used in cordless mode for
up to 90 minutes.

6
INSTRUCTIONS FOR USE
BEFORE STARTING THE CUT
• Inspect the clipper making sure that it is free from hair and dirt.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
TO ATTACH A COMB
• Hold the comb with its teeth upward.
• Align the legs of the comb with the holes in the top of the clipper on each side of the
blade and slide the legs into the trimmer until they click (Fig B).
• To remove, rmly pull the comb straight up away from the clipper.
SETTING THE LENGTH OF CUT
• Your clipper comes with three adjustable combs 3 to 13 mm, 14 to 24 mm and 25 to 35
mm.
• These provide a length of cut that can be adjusted between 3 and 35 mm in
increments of 1 mm.
1. Select the comb that ts the range of cut you want to achieve.
2. Fit the comb then rotate the length adjustment dial until the length you want appears
in the length selection window for that comb.
3. The length setting colour on the wheel matches the length marker colour on the
comb.
4. For example, if you want a cut length of 20 mm, t the 14 to 24 mm comb then turn the
dial until 20 appears in the length setting window for the 14 - 24 mm comb.
5. Use the clipper without any xed combs for trimming hair close to the skin.
6. This will trim hair to 1mm, holding the clipper so the blades are perpendicular to the
skin will trim hair to 0.5mm.
INSTRUCTIONS FOR CUTTING HAIR
• For even cutting, allow the comb attachment/blade to cut its way through the hair. Do
not force it through quickly. If you are cutting for the rst time, start with the maximum
comb attachment.
STEP 1 – NAPE OF THE NECK
• Set the comb to 3 mm or 6 mm.
• Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of
the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
STEP 2 – BACK OF THE HEAD
• With the comb set at 12 mm or 18 mm, cut the hair at the back of the head.

7
STEP 3 – SIDE OF THE HEAD
• With the comb set at 3 mm or 6 mm, trim sideburns. Then change to the longer 9 mm
guide comb and continue to cut the top of the head.
STEP 4 – TOP OF THE HEAD
• Use the longer length comb attachment and set it to 24 mm or 27 mm then cut hair on
top of the head against the direction in which the hair normally grows.
• For longer hair on top, use the longer length comb attachment (25 – 35 mm) to achieve
the desired style.
• Always work from the back of the head.
STEP 5 – THE FINISHING TOUCHES
• Use the clipper without an attachment comb for close trimming around the base and
sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper.
• Place the reversed clipper at right angles to the head, tips of the blades lightly
touching the skin and then work downwards.
MICRO FADE ADJUSTABLE COMB
The micro fade adjustable comb allows precision cutting in the 1 to 5 mm range.
Use the adjustment dial to set the comb to the desired length.
AUTO TURBO SYSTEM
• When switched on, your clipper runs in normal mode. The Auto Turbo feature will
automatically activate when the clipper senses it needs more power.
• To run in Turbo mode, slide the on/o switch to the turbo position.
CARE FOR YOUR HAIRCLIPPER
• Your clipper is tted with high quality blades.
• To ensure long lasting performance of your clipper, clean the blades and unit regularly.
• Always keep the attachment guide comb on the trimmer blade.
AFTER EACH USE
• Ensure the appliance is switched o and unplugged from the charger before cleaning.
• Brush the accumulated hair from the blades and body of the clipper. Do not submerge
the clipper in water.
• To clean unit, wipe with a damp cloth and dry immediately.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe o excess oil.
WASHABLE BLADE CLEANING
• This clipper is fully washable and therefore can be rinsed under a running tap.
• To remove the blades ensure the unit is switched o. Push the blade set away from the
clipper body using your thumb (Fig A).
• To reattach once the blades are cleaned and dry, align the bottom of the blade with
the bottom blade housing tab and slide the cartridge back into place until you hear a
click.

8
CLEANING CAUTIONS
• Do not use harsh or corrosive cleaners on the units or their blades.
• Ensure the appliance is switched o and unplug from the main outlet before cleaning.
REMOVING THE RECHARGEABLE BATTERY
We strongly recommend that a professional removes the rechargeable battery. Parts of the
shaver case, and tools have sharp edges and may cause injury if not handled correctly.
• The battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.
1. Ensure that the battery is fully discharged. To do this, operate the device until it stops.
2. Pry o and remove the top panel.
3. Unscrew the 2 screws from the top housing.
4. Pry o and remove the top housing.
5. Unscrew the 3 screws on the inner housing then remove the inner housing.
6. Remove the battery assembly.
7. Cut the battery tabs and remove the battery from bracket.
• The battery must be disposed of at an appropriate ocial recycling/collection point.
• Do not attempt to operate the trimmer once you have opened it.
ADAPTER SPECIFICATIONS
Manufacturer address and
registration number
Spectrum Brands (UK) Limited, Regent Mill, Fir Street,
Failsworth, Manchester M35 0HS
Company number: 02394603
Adapter model number PA-0510U
Input voltage 100 - 240 V~
Input AC Frequency 50/60Hz
Output voltage 5.0 V
D
Output current 1.0 A
Output power 5.0 W
Average active eciency ≥73.7%
Eciency at 10% -
No load power consumption ≤0.1W

9
RECYCLING
WTo avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate ocial recycling/
collection point.

10
SERVICE AND GUARANTEE
Defects aecting product functionality appearing within the guarantee
period will be corrected by replacement or repair at our option
provided the product is used and maintained in accordance with the
instructions. Your statutory rights are not aected.
To claim an extra 1 year guarantee, register your product online within
28 days of purchase.
This warranty shall not be valid where it is contrary to U.S. and other applicable laws, or
where the warranty would be prohibited under any economic sanctions, export control
laws, embargos, or other restrictive trade measures enforced by the United States or other
applicable jurisdictions. This includes, without limitation, any warranty claims implicating
parties from, or otherwise located in, Cuba, Iran, North Korea, Syria and the Crimea region.
Register at: https://uk.remington-europe.com/product-registration
Consumables are guaranteed only for their recommended lifecycle. Replacement/spare
parts* are excluded and are only covered by a 1 year warranty.
*Examples include, but are not limited to, adaptors, haircare attachments, grooming accessories, etc.
$

11
SERVICE CENTRE
UNITED KINGDOM
G 0800 212 438 (free call mainland UK)
Spectrum Brands (UK) Ltd
Fir Street, Failsworth, Manchester
M35 0HS, UK
www.remington.co.uk
Product support:
[e-mail]
IRELAND
G 142 951 40
Remington Consumer Products,
Unit B12, Ballymount Corporate Park,
Ballymount, Dublin 12
https://ie.remington-europe.com
Product support:
[e-mail]

Ref. No. HC6000
Type No. HC18A
20/UK/ HC6000 T22-7001608 Version 10 /20
Remington® is a Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries.
Spectrum Brands (UK) Ltd
Fir Street,
Failsworth,
Manchester
M35 0HS
remington-europe.com
© 2020 Spectrum Brands, Inc.