RenewAire SL70H User manual

Instruction Sheet: SL70H, SL70L
Airflow Balancing Instructions
BALANCING
Balancing an airflow is done by setting the Outdoor Air fan speed and then adjusting the Return Air fan speed to
eject the same or somewhat less air to the outdoors.
Equipment required for testing airflows:
uA magnehelic gauge (or manometer) or other device capable of measuring 0–1.0 in. w.g. of differential pressure.
u2 pieces of natural rubber latex tubing, 1/8" I.D., 1/16" wall thickness works best.
Manometers are relatively inexpensive devices that are readily available from online retailers. Accuracy within
the range of 0–1.0 in. w.g. is the critical measure. Water manometers generally have graduations of 0.1" that are
difficult to accurately determine. For all manometers, there are two plastic tubes that connect at the manometer
and then the other ends go to pressure ports on the SL.
Individual differential static pressures (DP) are measured ACROSS the core, using the installed pressure ports
located on the removable door.
USE THESE TWO PRESSURE PORTS TO
CHECK PRESSURE DROP FOR THE RA
AIR STREAM
USE THESE TWO PRESSURE PORTS TO
CHECK PRESSURE DROP FOR THE OA
AIR STREAM
FIGURE 1.0 PRESSURE PORT LOCATIONS

Member of the S&P Group
Family of Brands
2020 © RenewAire LLC
164132_000_SEP20
uVerify the unit has clean filters in place.
uInstall a jumper between the 24VAC and LOW SPEED terminals so that the unit is forced into Continuous (low
speed) mode.
uPress the PROGRAM button to begin changing the fan settings. The yellow LED will blink slowly.
uOpen the pressure port caps for the OA air stream and then insert the tubing into the openings about 1".
uTake a differential pressure reading for the OA airstream and compare the pressure drop to the chart on the unit
or in the IOM to obtain the CFM. Adjust the potentiometer marked OA-L to obtain the desired CFM. Record the
CFM setting for future reference.
uTake a differential pressure reading for the RA airstream and compare the pressure drop to the chart on the unit
to obtain the CFM. Adjust the potentiometer marked RA-L to obtain the desired CFM. Record the CFM setting for
future reference.
uRemove the jumper wire and reinstall it between the 24VAC and HIGH SPEED terminals so that the unit is forced
into Boost (high speed) mode.
uRepeat the process for both airstreams to set both the CFM and balance using the OA-H and RA-H
potentiometers. Record the CFM setting for future reference.
uAfter adjusting the potentiometers, take additional readings as needed to verify that fan speed settings are
correct. See illustration below.
uPress the PROGRAM button to store the new fan settings. The yellow LED will flash quickly to indicate that the
settings have been stored.
POTENTIOMETERS ARE VISIBLE
AND ACCESSIBLE THROUGH THE
OPENING IN THE UNIT DOOR
FIGURE 1.1 FAN SPEED CONTROL POTENTIOMETERS