Resolution RE112 User manual

RE112_GE-Compat_Smoke_Instructions Page 1 of 3 29-Oct-14
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
RE112 GE-Compatible Smoke & Heat Alarm
Features
• UL217 Self-Contained Fire Alarm Device
• Senses and alarms to Smo e per UL217
• Heat alarm at 144 degrees.
• Slee design.
• Cover tamper.
• Strong, reliable RF signal.
• 3-5 year battery life on Panasonic CR123A battery.
• Low Battery indication.
Ke Instructions
1. Attach the mounting plate
Locate on ceiling, as close to center as possible, away from corners.
Some local codes may allow wall mounting.
Mounting plate removes counter-cloc wise
2. Insert battery with MINUS towards the RED lever. Close battery door.
3. Enroll sensor in panel:
a) Place panel in Learn Sensor mode
b) Press & release the blac tamper switch
Sounder will continue beeping 3 times, until sensor is mounted.
c) Recommended GE Group # (26)
4. Testing:
a) Place panel in Sensor Test mode
b) Press & hold TEST button until you hear the sounder beep.
d) Panel will indicate the sensor is open, but Fire Alarm will not sound.
NOTE: Using Smo e-in-a-Can will cause an actual Fire Alarm.
Operation
Situatio
n
Sounder
LED
Wireless Signal
to Panel
Recover
Actual smo e
Temporal 3
(Loud)
RED
(pulsing)
Wireless Fire
Alarm Signal sent
to panel
When smo e is no
longer present.
TEST button will
silence sensor for 10
minutes.
Press & hold
Test Button
Temporal 3
(Loud)
RED
(pulsing)
Sensor Open
signal to panel
Sensor: Release
button.
Panel: Restore when
TEST button is
released
Removing
Sensor from
Mount
Temporal 3
(Loud)
Yellow
(steady)
Tamper/Trouble
signal to be sent
to panel.
Restore by
remounting.
Low Battery
1 Chirp every
43 seconds
Yellow
(pulsing)
Low battery
Hourly Chec
Supervisories,
every hour
Maintenance
Needed
Temporal 3
(Loud)
Yellow
(Pulsing)
Supervisories Not
Sent
Replace Unit
Available for…
GE
Honeywell
DSC
2GIG
RE112_GE-Compat_Smoke_Instructions Page 2 of 3 29-Oct-14
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Specifications
Approval: UL217 Self-Contained Fire Alarm Device
Smo e Sensitivity: 1.31 – 2.28 %/ft (UL 217)
0.11 – 0.165 dB/m (EN54-7)
Smo e Sensing Technology: Photoelectric
521)
Alarm Sound: Temporal Three
Replacement Battery: Panasonic CR123A
Temperature Range: 32 to 120 F (Long Term)
Humidity: 10 – 85% Relative Humidity
Housing dimensions: 4.7 inch diameter, 2.1 inch high
Design & Manufacture: Resolution Products, Inc.
Specifications subject to change without notice.
Pictures
TEST Button
LED
Battery
+
Smoke Sensing
Element
Mounting
Tabs
Tamper
Heat Sensor

RE112_GE-Compat_Smoke_Instructions Page 3 of 3 29-Oct-14
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Notices
erify proper enrollment and operation, per control panel installation instructions, at installation.
PHOTOELECTRIC SMOKE & HEAT USER'S MANUAL, which is included in device box, is an integral part
of the operating information of the RE112 device.
Approved as a self-contained fire alarm device per UL217. This represents the ability of each
individual sensor to sound locally upon sensed fire conditions.
“GE”, “Interlogix”, “Honeywell”, “2GIG”, “DSC”, “Napco” are trademarks owned by General Electric
Company, UTC Fire & Security Americas Corporation, Inc., Honeywell International Inc., 2GIG
Technologies Inc., Tyco Safety Products Canada LTD, Napco Security Systems respectively.
Resolution Products, Inc. products will function with one of either GE/Interlogix, Honeywell and
2GIG, DSC or Napco. However, no Resolution product is produced by, endorsed by, nor is officially
associated with any of these other manufacturers. Resolution recommends verifying proper
enrollment and operation, per control panel installation instructions, at installation.
Warranty
Resolution Products, Inc. will replace products that are defective in their first five (5) years.
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference.
This device must accept any interference that may be received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the Resolution Products, Inc. could void
the user's authority to operate this equipment.
FCC ID: U5X-RE112
IC Notice
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1)This device may not cause interference, and
(2)This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1)l'appareil ne doit pas produire de brouillage, et
(2)l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
IC: 8310A-RE112