Resolution RE212T User manual

RE212T_2GIG-Compat_Smoke_Instructions Page 1 of 4 22-Feb-16
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
RE212T 2GIG-Compatible Smoke & Heat Alarm
Features
• UL217 Self-Contained Fire Alarm Device
• Senses and alarms to Smo e per UL217
• Heat alarm at 144 degrees.
• Slee design.
• Cover tamper.
• Strong, reliable RF signal.
• 3-5 year battery life on Panasonic CR123A battery.
• Low Battery indication.
Key Instructions
1. Attach the mounting plate
Locate on ceiling, as close to center as possible, away from corners.
Some local codes may allow wall mounting.
Mounting plate removes counter-cloc wise
2. Insert battery with MINUS towards the RED lever. Close battery door.
3. Enroll sensor in panel:
Q1: Select RF sensor (01-48) Zone number of your choice
Select RF sensor type [09] 24-Hour Fire, or [16] 24-Hour Fire w/
Verification (See Control Panel Installation
Manual)
Select RF sensor equip type [1] Contact
Select RF sensor equip code [0872] SMKE1-345 smoke detector
Select RF sensor serial number Press Shift, Press Learn
Press and hold the TEST Button for 5 seconds
Select RF sensor Age [1] New
Select RF sensor Loop number [1] Motion
4. Testing:
a) Place panel in Sensor Test mode
b) Press & hold TEST button until you hear the sounder beep.
c) Panel will go into alarm.
NOTE: Using Smo e-in-a-Can will cause an actual Fire Alarm.
Available for…
GE
Honeywell
2GIG
DSC
Answer
Question
RE212T_2GIG-Compat_Smoke_Instructions Page 2 of 4 22-Feb-16
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Operation
Situation
Sounder
LED
Wireless Signal
to Panel
Recovery
Actual smo e
Temporal 3
(Loud)
RED
(pulsing)
Wireless Fire
Alarm Signal sent
to panel
Silence an actual
alarm with the TEST
button. Sensor will
return to alarm if
smo e is still
present.
Pre
ss & hold
Test Button
Temporal 3
(Loud)
RED
(pulsing)
Sensor Alarm
signal to panel
Sensor: Release
button.
Panel: Restores after
alarm is cancled
Removing
Sensor from
Mount
Temporal 3
(Loud)
Yellow
(steady)
Tamper/Trouble
signal to be sent
to panel.
Rest
ore by
remounting.
Low Battery
Yellow
(pulsing)
Hourly Chec
Supervisories,
every hour
Maintenance
Needed
Temporal 3
(Loud)
Yellow
(Pulsing)
Supervisories Not
Sent
Replace Unit
Specifications
Approval: UL217 Self-Contained Fire Alarm Device
Smo e Sensitivity: 1.31 – 2.28 %/ft (UL 217)
0.11 – 0.165 dB/m (EN54-7)
Smo e Sensing Technology: Photoelectric
Heat Alarm Point: 135 – 149 F (UL 521)
Alarm Sound: Temporal Three
Replacement Battery: Panasonic CR123A
Temperature Range: 32 to 120 F (Long Term)
Humidity: 10 – 85% Relative Humidity
Housing dimensions: 4.7 inch diameter, 2.1 inch high
Design & Manufacture: Resolution Products, Inc.
Specifications subject to change without notice.

RE212T_2GIG-Compat_Smoke_Instructions Page 3 of 4 22-Feb-16
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Pictures
Battery
+
Smoke Sensing
Element
ounting
Tabs
Tamper
Heat Sensor
TEST Button
LED
RE212T_2GIG-Compat_Smoke_Instructions Page 4 of 4 22-Feb-16
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Notices
Verify proper enrollment and operation, per control panel installation instructions, at installation.
PHOTOELECTRIC S OKE & HEAT USER'S ANUAL, which is included in device box, is an integral part
of the operating information of the RE212T device. However, this is NOT a heat device.
Loop 2 Maintenance is only supported on commercial control panels. See Honeywell Installation Manual.
Approved as a self-contained fire alarm device per UL217. This represents the ability of each
individual sensor to sound locally upon sensed fire conditions.
“GE”, “Interlogix”, “Honeywell”, “2GIG”, “DSC”, “Napco” are trademarks owned by General Electric
Company, UTC Fire & Security Americas Corporation, Inc., Honeywell International Inc., 2GIG
Technologies Inc., Tyco Safety Products Canada LTD, Napco Security Systems respectively.
Resolution Products, Inc. products will function with one of either GE/Interlogix, Honeywell and
2GIG, DSC or Napco. However, no Resolution product is produced by, endorsed by, nor is officially
associated with any of these other manufacturers. Resolution recommends verifying proper
enrollment and operation, per control panel installation instructions, at installation.
Warranty
Resolution Products, Inc. will replace products that are defective in their first five (5) years.
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference that may be received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the Resolution Products, Inc. could void
the user's authority to operate this equipment.
FCC ID: U5X-RE212
IC Notice
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1)This device may not cause interference, and
(2)This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1)l'appareil ne doit pas produire de brouillage, et
(2)l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
IC: 8310A-RE212