RH HAYES User manual

HAYES FLOOR LAMP
P A R T S E N C L O S E D
(A) Finial
(B) Shade (sold separately)
(C) Bulb (1)
(D) Harp
(E) Lamp Body
Page 1 of 2
(D)
(E)
(F)
(F) Adjustment Key (2) (A)
(B)
(F)
(G)
(C)
(G) Tube

HAYE S FLOOR LAM P
This portable luminaire has a polarized plug (one blade is wider
than the other) as a feature to reduce the risk of electric shock.
This plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. Never use with an extension
This fixture has been rated for one (1) 5-Watt TYPE A15 Dimmable
LED lightbulb (included). To avoid the risk of fire, do not exceed
the recommended wattage.
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow it
to cool prior to replacing the lightbulb. Do not touch or look directly
at the bulb when fixture is illuminated. Keep flammable materials
away from lit bulb.
W A R N I N G : This product can expose you to lead, which is
known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 feet away from cribs, bassinets, and toddler beds.
Keep out of reach of children under 3 years of age.
A S S E M B LY & I N S T A L L A T I O N
1. Carefully remove all parts from the box and remove all plastic
coverings.
2.
Place the Lamp Body (E) on the floor.
4.
CARE INSTRUCTIONS
Wipe all surfaces with a soft, dry cloth. Do not use any harsh cleaners
(including ammonia-based products) or abrasives on your lamp, as they
3.
Insert the Bulb (C) into the socket.
will damage the finish.
Page 2 of 2
IMPORTANT SAFETY INSTRUCTIONS
cord unless plug can be fully inserted. Do not alter the plug.
W A R N I N G S
6. Plug into proper electrical outlet and test fixture.
5. Assembly is complete.
Place the Shade (B) (not included) over the Harp (D) and secure
with Finial (A).
HEIGHT ADJUSTMENT
1. Loosen the Tube (G) by turning the Adjustment Key (F) in a
counterclockwise direction.
2. Adjust lamp by pulling or pushing the Tube (G) up or down to
desired height.
3. Tighten the Adjustment Key (F) in a clockwise direction.
THIS PRODUCT IS NOT A TOY AND HAS NO PLAY
VALUE.