Rhythm Healthcare P2 User manual

P2
Now that you have unpacked each box, you have
everything you need to start using your P2. The
set-up of your P2 is quick and simple.
Before using the P2, please read and understand
the entire user manual.
If you have any questions, please contact your
provider before use.
Portable Oxygen Concentrator
P2
GETTING STARTED GUIDE

Simple Steps
to Independence
1 3
4
5
2
Find a well
ventilated
location to place
the P2. Make sure
intake and
exhaust fan is
clear and nothing
is blocking it.
Plug the AC cord
into the nearest
electrical outlet.
Press the ON/OFF button
for one second. It will
beep and the indicator
light will flash. Wait two
minutes for the machine
to warm up.
Slide flat side of the
battery into place until
the latch returns to the
upper position and you
hear it click into place.
Connect the AC connector to
the P2. The green LED on the
power adapter will be on
and the concentrator will
beep.

6 8
7Change the P2 Concentrator setting to
the flow rate prescribed by your
physician or clinician.
Press the + or – setting buttons for the
desired setting.
ADDITIONAL INFORMATION:
When adapter is connected/disconnected
or battery is installed/uninstalled, unit will
beep and the display will show power
supply information.
Join the nasal cannula to the
nozzle fitting. Ensure that the
cannula is routed to prevent it
from being pinched or kinked
to avoid a disruption of
oxygen flow.
TO SHUT DOWN:
Press and hold the ON/OFF
button for 3 seconds.

Intake Filter - Item # P2FC-1
In normal use conditions, the air filter must be replaced after approximately 6 months of daily use. When conditions are subject to
higher levels of dust or dirt, we recommend periodically checking the air filter and if the filter shows a grey or brown color, replace it.
The intake filter is designed to ensure clean air enters the compressor. To replace the intake filter:
1. Unscrew the bottom of the pre-filter with a Philips screwdriver.
2. Lift up the pre-filter from the bottom end, then remove it.
3. Remove the intake filter from the intake chamber.
4. Insert a new intake filter into the chamber;
5. Reinstall the pre filter.
Replacement pre-filters and intake filters can be purchased from your equipment provider.
Battery Care and Maintenance
The P2 Lithium Ion Battery requires special care to ensure proper performance and long life.
Use only P2 batteries #P2BY001-1 (compatible with batteries with Lifestyle logo) and
P2BY001-2 (compatible with batteries with Rhythm logo) with your concentrator.
CAUTION
Keep liquids away from batteries.
If batteries become wet, stop use immediately and dispose of battery properly.
Battery Replacement
2. Press down the latch, and slide the battery out.
2. Insert the new P2 battery by sliding battery into place until the latch returns to the upper position.

Store battery in a cool, dry
place. Store with a charge
of 40-50%.
Batteries should not be
left dormant for more
than 90 days at a time.

Rhythm Healthcare, LLC
[email protected]
www.rhythmhc.com