RIB ALTAIR 3P User manual

Assembly of ALTAIR 3P / NEPTUNE 3P Handle on axle
(Left Hand Side handle version)
1: Raise the Backrest
ATTENTION: NEVER FORCE THE MECHANISM!
1 – Press the release lever and hold it in position
2 – Rotate the triangular plate of the handle
simultaneously with the opposite plate, up to
position “B”.
3 – Release the handle when the 2 triangular
plates are well aligned in position “B”
Remove the nuts and washers
1
2
2
3
Backrest in sleeping position
- Pull up the bar
- Initiate The Rotation Forward
- Release the bar
B
A
FROM
2: Assembly of the seat cushion
- Remove the cover and the protection-cardboard
around articulation.
- Rotate the hinge plates of the seat.
3: Approximate alignment of the triangular
plates in position “B”
4: WHAT TO DO IN CASE OF BLOCKED PLATE
1 – Press the release lever and hold it in position
2 – Bring back the hinge on handle side to the
position “A”
3 – Rotate the triangular plate of the handle
simultaneously with the opposite plate, up to
position “B”
USE TWO PEOPLE IF NECESSARY
4 – Release the handle when the 2 triangular
plates are well aligned in position “B”
1
3
3
4
B
A
2
PAGE 1 - 2

PAGE 1 - 2
FROM
PAGE 2 - 2
8: Operating sleeping position
5: Screwing of the cushion
1 – Screw the triangular plate on the opposite side of
the handle (torque N.m 24 maximum)
2 – Press the release lever and hold it in position
3 – Lower the hinge onto the bolts of the frame
4 – Release the lever
5 – Screw the second hinge on handle side
24 N.m tightening torque maximum)
1
2
3
4
5
6: Rotation of the cushion
1 – Press the release lever and hold it in position
2 – Rotate the seat cushion to the required position
3 – Release the lever
1
3
2
7: Assembly of the rear back
(only for model ALTAIR 3 P)
Proceed in the same way for the Assembly of the rear
backrest (rotation of the handle in the opposite direction
of the seat cushion one)
Day / driving
position :