Riester ALL PUPIL II Installation instructions

CONTENTS
1. Symbols
2. Warnings & Cautions
3. Environmental
4. Description of Product
5. Inserting / Replacing Batteries
6. Wall Mounting
7. Charging
8. Charging Cycle
9. Warranty & Service
10. Technical Information
11. Cleaning Instructions
12. Contact Details
1.0 Symbols
Attention. Read operating manual for cautions and instructions for use
The CE mark on this product indicates it has been tested to and conforms with
the provisions noted within the 93/42/EEC Medical Device Directive
!
ALL
PUPIL II
All Pupil II
Wall mounting and safety instructions
All Pupil II without cable

CONTENTS
1. Symbols
2. Warnings & Cautions
3. Environmental
4. Description of Product
5. Inserting / Replacing Batteries
6. Wall Mounting
7. Charging
8. Charging Cycle
9. Warranty & Service
10. Technical Information
11. Cleaning Instructions
12. Contact Details
1.0 Symbols
Attention. Read operating manual for cautions and instructions for use
The CE mark on this product indicates it has been tested to and conforms with
the provisions noted within the 93/42/EEC Medical Device Directive
!

2.0 Warnings & Cautions
Carefully read this instruction section before using your Riester product. For your own safety and
that of your customers observe all cautionary information provided in this section. The following
information is intended to highlight potential safety hazards that can be associated with misuse,
or damage.
Warning
This product must not be used in the presence of ammable gases.
Do not disassemble or modify the battery. There are no serviceable parts inside.
Do not dispose of battery in re, puncture or short curcuit.
Do not use a battery that is deformed, leaking, corroded or visually damaged. Handle a
damaged or leaking battery with extreme care. If you come into contact with electrolyte,
wash the exposed area with soap and water. If it contacts the eye, seek medical attention
immediately.
If the product emits a strange odour, heat or smoke, stop use immediately. The continued use
of a damaged product or part may cause injuries.
Do not immerse the unit in any liquid.
Do not use unit if damaged and periodically visually inspect for signs of damage.
Do not t in damaged mains socket.
In the event of poor contact, pins can get hot. Care should be taken when removing.
Avoid trailing cables as potential trip hazards.
Federal law restricts this device to sale by or order of a physician.
Caution
Use only Riester battery
Charge only using Riester charger
Do not charge battery in any environment where the temperature may exceed 40º C or fall
below 0ºC.
Keep out of reach of children
For indoor use only (protect from moisture)
To prevent condensation from forming, allow instrument to come to room temperature before
use.
When replacing Lithium battery pack, turn indirect off and attach a new pack.
Electrical equipment can be effected by electromagnetic interference. If this occurrence
happens whilst using this equipment, switch the unit off and reposition.
!
!

3.0 Environmental
Dispose of battery in line with local regulations on recycling batteries.
Tape over battery contacts to avoid short circuiting during disposal.
Li-ion batteries contain no toxic heavy metals, such as mercury, cadmium or lead.
4.0 Description of Product
Charger
Power
Input
Socket
Headband Adjustment
Battery
Pack
Headband
Headband Adjustment
Vantage

5.0 Inserting/Replacing Battery Pack
Release battery by pressing release switch as shown and lift battery pack from cradle.
To insert new battery pack, place in cradle until fully engaged.

6.0 Wall Mounting
6.1
6.2
6.3
6.4 CAUTION
Check
!

7.0 Charging
Replace the blanking plate with the appropriate mains plug adapter, and connect plug on cable
to power input socket on charger.
Switch on your Lithium Charger by plugging it into a mains outlet. Place your spare battery
pack or headset into your Lithium Charger as shown.

Lithium Battery
Flashing LED - Battery requires charging.
Charging Station
No LED - Battery is fully charged.
Flashing LED - Top up charge.
Solid LED - Rapid Charge.
The battery pack can be used at any time during the charging cycle and will automatically
resume charging when battery pack is placed back in the charger.
Direction arrow on charger indicates which battery is being charged. (probably requires a
drawing of some kind).
8.0 Charging Cycle
The battery attached to the indirect will take approximately 2 hours to fully charge.
The battery will last approximately 1 hours on full power.
Charging Battery
on Headband
Charging Spare
Battery only

9.0 Warranty & Service
No user serviceable parts – all preventative maintenance and servicing must only be performed
by authorised Riester representatives.
Your Riester Charger is guaranteed for 3 years and will be replaced or repaired free of charge
subject to the following:-
9.1 Any fault is due to faulty manufacture.
9.2 The power supply has been used in compliance with these instructions.
9.3 Proof of purchase accompanies any claim.
Batteries are guaranteed for 1 year from date of purchase.
10.0 Technical Information
Input data see name plate: 100-240V - 50/60Hz
Power Supply Rating: 12V : 2.5 Amps
Operation: Continuous
Classication: Class II equipment
Type B Protection against electric shock
Safety Class: Double insulated
Ambient Temperature: +10oC to +35oC
Transportation: -40oC to +70oC 10% to 95% RH
Standards: IEC60601-1 Electrical Safety / IEC 60601-1-2 EMC
ISO9022-2 Environmental
ISO9022-3 Environmental
11.0 Cleaning Instructions
Only manual non-immersion cleaning as described below should be used for the instrument.
11.1 Wipe the external surface with a clean absorbent, non shedding cloth dampened with a
water / detergent solution (2% by volume) or water / isopopyl alchohol solution (70% by
volume).
11.2 Ensure that excess solution does not enter the instrument. Use caution to ensure cloth
is not saturated with solution.
11.3 Surfaces should be carefully hand-dried using a clean non-shedding cloth.
11.4 Safely dispose of used cleaning materials.

Rudolf Riester GmbH
Postfach 35 •DE-72417 Jungingen
Deutschland
Tel.: [phone]
Fax: [phone]
[e-mail] •www.riester.de
Riester bietet eine große Produktauswahl in den
Bereichen
Blutdruckmessgeräte l Instrumente für H.N.O.,
Ophthalmologische Instrumente l Dermatologische
Instrumente l Thermometer l Stethoskope l Stirnspiegel,
Stirnlampen, Untersuchungslampen l Laryngoskope l
Gynäkologische Instrumente l Perkussionshämmer l
Stimmgabeln l Produkte zur Blutstauung I
Lungendruckmessgeräte l Dynamometer
lDruckinfusionsgeräte l Veterinärmedizinische Instrumente
l Arztkoffer/ -taschen
Die detaillierten Beschreibungen der Produkte
finden Sie unter der jeweiligen Rubrik im
Gesamtkatalog (Best. Nr. 51231-50). Oder gehen
Sie online unter www.riester.de.
Riester offers a large selection of products in the
areas of
Blood pressure measuring devices I Instruments for
ENT, Ophthalmological instruments I Dermatological
instruments I Thermometers I Stethoscopes I Head
mirrors, Head lights, Examination lights I
Laryngoscopes I Gynaecological instruments I
Percussion hammers I Tuning forks I Products for
blood stasis I Pulmonary pressure measuring devices I
Dynamometers I Pressure infusion instruments I
Veterinary instruments I Doctor’s cases and bags
Detailed descriptions of the products can be
found in the respective sections of the omnibus
edition catalogue (Order No. 51232-50).
Or online under www.riester.de.
All Pupil II
99331 Rev. 02009-05 · Änderungen vorbehalten · Subject to alterations · Sous réserve de modifications · Sujeto a modificaciones