Riverside Furniture 32420 User manual

Riverside
FURNITURE
email: [email protected]
Coventry
Home Office
Assembly Instructions Made in China
age 1 of 2
1 pc. 2 pcs. 1 pc.
8 pcs. 8 pcs. 8 pcs.
1 pc. 4 pcs. 4 pcs.
4 pcs. 1 pc. 2 pcs.
WRITING DESK
Step 1. Place the Writing Desk Top (A) and End Frames (B) face do n on a clean and soft surface.
If the Corner Unit ill be connected to this desk, remove the hole covers from the appropriate End Frame.
Step 2. Assemble the L-Brackets (L) to the End Frames using the Allen Head Bolts (H) Spring Washers (J)
and Flat Washers (I). Tighten ith the 4mm Allen Wrench (K) as sho n.

pull out pull out
Riverside
FURNITURE
email: [email protected]
Coventry
Home Office
Assembly Instructions Made in China
age 2 of 2
If it becomes necessary to remove a drawer, follow
these steps. With the drawer fully open, the drawer
slides must be released by pushing the "trigger" located
in the slide either up or down, depending on which
slide is being released. With both triggers pushed,
gently pull the drawer until the slides release.
Carefully reinstall the drawers by aligning the channels
of the drawer slides and gently pushing the drawers
back into the cabinet.
Step 3. Connect one nd Frame to the end of the Top Frame, using the Allen Head Bolts (D), Spring
Washers (F), and Flat Washers ( ). Do not fully tighten until the entire Desk has been assembled.
Step 4. Position the Back Stretcher between the two nd Frames and attach the remaining nd Frame using
the same Bolts and Washers as in the previous step.
Step 5. Tighten Bolts previously installed using the 5mm Allen Wrench.
Step 6. Connect the ends of the Back Stretcher using the Allen Head Bolts (H), Spring Washers (J) and Flat
Washers (I). While pulling end of Stretcher snug to the nd Frame, tighten bolts using the 4mm Allen
Wrench (K).
Carefully set the Desk
upright and reinstall
Drawers back into
the Desk if necessary.
There are levelers located in
the bottom of the Legs which
can be adjusted to compensate
for uneven flooring if needed.