Riverside Furniture Myra 59398 User manual

#59398
Xx Back Uph Arm Chair
Riverside
Components and Hardware List
email: [email protected]
FURNITURE
Made in Viet Nam
Page 1 of 2
Back Assembly
A
Myra
Dining Room
Assembly Instructions
1 pc. BC
I
EF
Chair Seat
M5/16"-18 x 3"
Long Allen Head
Bolt
5mm Allen
Wrench
5/16" *19*2mm
Flat Washer
5/16" Spring
Washer
1 pc.
G
4 pcs. 9 pcs. 9 pcs.
Besuretocheckallpackingmaterialcarefully
forsmallparts,whichmayhavecomeloose
insidethecartonduringshipment.
5 pcs.
Front Leg
(right and left)
2 pcs.
H
J
1 pc.
M5/16"-18 x 2"
Long Allen Head
Bolt
#8 x 1-1/8"
Wood Screw
2 pcs.
Steps:
1. Place the Back Assembly (A) on a soft and smooth surface.
2. Attach Chair Seat (B) to the Back Assembly (A) by using the 3" long Bolt (F) Spring Washer (G) and
Flat Washer (H) into the back corners of the Seat and 2" long Bolt (E) Spring Washer (G) and Flat
Washer (H) into the middle of the Seat, as shown in (Detail A). Do not fully tighten Bolts until
after next step.
Detail A
A
B
F
I
HG
IEGH

Riverside
email: [email protected]
FURNITURE
Made in Viet Nam
Page 2 of 2
Myra
Dining Room
Assembly Instructions
I
E
G
H
C
J
JJ
Detail B
3. Attach Front Legs Left and Right (C) to the Chair Seat (B) by using the 2" long Bolts (E) Spring Washer
(G) and Flat Washer (H) as shown in (Detail B). Attach to the Back Assembly (A) by using Screw(J) as
shown in (Detail C)
4. Turn the Chair upright on a flat surface to level chair and tighten all Bolts using the Allen Wrench (I).
Detail C