Roberts CR9932 User manual

CR9932
3 Band SingleAlarm
Night Light Clock Radio
ROBERTS
SoundforGenerations
Please read this manual before use

Controls
(Top) 3
(Left side) (Right side)
1
1. Dimmer switch
2. Function switch
3. Headphonesocket
4. Volume control
9. Alarm/Offbutton
10. Time button
11. Minute button
12. Hourbutton
5. Wavebandselector
6. Tuningcontrol
7. Snooze/nightlightbutton
8. Sleepbutton
4
5
6
2
1
12 11 10 9 8 7

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri) 2
Controls
(Front)
13. PM indicator
14. LED dial pointer
15. Battery compartment (underside)
16. Alarm indicator
16 15
14
13

Switching on and setting the time
Before using your clock radio you must first set the correct time.
1. Place the unit on a flat surface. Plug the power cord into the wall
socket and switch on.
2. The clock display will flash 12:00.
3
3. Press and hold down the Time Set button.
4. Whilst holding down the Time Set button press the Hour, or
Minute buttons to set the time. Release the buttons when the
correct time is reached. The clock uses a 12 hour display with a
PM indicator. Ensure that the correct 12 hour cycle is selected.

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri) 4
4. Adjust the volume by rotating the Volume control.
3.Tune in to the desired station by rotating the Tuning control.
The station frequency is indicated by the LED dial pointer.
The Wire aerial located on the rear of your clock radio is for FM
reception. The wire should be fully extended and positioned for
optimum reception.
For MW and LW reception there is a built-in ferrite aerial. Rotate
your clock radio to the position giving best reception.
2.Select the required waveband using the Waveband selector
switch.
Listening to the Radio
1. Turn on the radio by sliding the Function switch to the 'On '
position. The LED dial pointer will light up indicating that the
radio is switched on.
5. The radio can be switched off by sliding the Function switch to
the 'Off ' position.

Alarm
The alarm can be set to wake you by either the buzzer or the radio.
Setting alarm time
1. Press and hold down the Alarm/Off button.
2.Whilst holding down the Alarm/Off button press the Hour, or
Minute buttons to set the time. Release the buttons when the
correct alarm time is reached. The clock uses a 12 hour display
with a PM indicator. Ensure that the correct 12 hour cycle is
selected.
Checking the alarm time
1. To check alarm time, press and hold down the Alarm/Off button
the display will show the alarm time
5

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
Setting the alarm to wake to buzzer
1. Set the alarm time as previously described. Set the Function
switch to the 'Buzz'position. The Alarm indicator will light.
The alarm will sound every day at the preset time for 59 minutes.
To turn off the alarm until the next day press the Alarm/Off
button. To turn off the alarms permanently set the Function
selector to the 'Off'position.
Setting the alarms to wake to radio
1.Set the alarm time as previously described. Set the Function
switch to the 'Auto'position. The Alarm indicator will light.
Ensure that the volume is set to the correct level and the desired
station is tuned in.
The alarm will sound every day at the preset time for 59 minutes. To
turn off the alarm until the next day press the Alarm/Off button.To
turn off the alarms permanently set the Function selector to the
'Off'position.
6

Snooze control
The radio or buzzer alarm can be silenced for 7 minutes by pressing the
Snooze Light button. This sequence can be repeated whilst the alarm
is sounding.
Sleep timer
The radio can be set to turn off after a preset time has elapsed.
Press and hold down the Sleep button until the desired time is reached
(maximum 59 minutes in 1 minute steps). The radio will switch off after
the sleep time has elapsed.
To cancel the sleep function before the preset time has expired, press
the Alarm/Off button.
Dimmer Switch
TheDimmer switch located on the left side of your clock radio will allow
you to adjust the intensity of the clock display to suit room brightness.
7

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
Night light
Press the Snooze button once to turn on the night light. Press
again to turn it off. The night-light will provide a warm glow adequate
to allow movement around the room safely. It is not intended as a
reading light.
Headphones (on rear)
A Headphone Socket (3.5mm) is provided for use with either
headphones or an earpiece . Inserting a plug automatically mutes
the internal loudspeaker.
8

9
General
Donotallowthisunittobe exposed towaterorsteam. It isrecommended
that the FM band be used wherever possible as better results in terms
of quality and freedom from interference will usually be obtained than
on the MW or LW bands.
Mains supply
TheCR9932will operate from a supply ofAC230volts,50Hz only.
For your convenience this product is supplied with a plug which is
fitted with a fuse of the appropriate rating. If the plug supplied is not
suitablefor your socket outlet,it should be removedby unscrewing the
plug top, the terminal screws, and removing the cable.
Thecorrectstyleof plug to suit your household together withacorrectly
rated fuse should be fitted.
IF IN DOUBT - CONSULTA QUALIFIED ELECTRICIAN
IMPORTANT.DONOT makeanyconnection tothelargerterminalwhich
ismarkedwiththeletterEorbythesafetyearthsymbol orcoloured
GreenorGreen-and-yellow.
Thewires in themainsleadarecoloured inaccordancewiththefollowing
codes :- BLUE - NEUTRAL BROWN - LIVE
As these colours may not correspond with the coloured markings
identifyingthe terminals inyour plug, proceed as follows:-
Thewire coloured BLUE must be
connectedtotheterminalmarked
N or coloured BLACK.
The wire coloured BROWN must
be connected to the terminal
markedL or coloured RED.
Fuse
Thisapparatusmust be protected bya 3Afuse (BS1362)in a 13Aplug
(BS1363). If another type of plug is used a 5A fuse should be fitted in
theplug, adaptor or distribution board.
IF IN DOUBT - CONSULTA QUALIFIED ELECTRICIAN.
Back-up Battery (not necessary for the unit to function)
Slide the battery cover catch in the direction of the arrow. Remove the
battery cover. Fit a 9 volt IEC size 6LR61(6F22,PP3) or equivalent
battery into the compartment. Replace the battery cover.
The time and alarm settings will be retained during a temporary failure
of theAC mains supply. The LED display will not be operational. The
display will be extinguished to conserve battery life.
(Underside)

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri) 10
The Company reserves the right to amend the specification without notice.
Specifications
Power Requirements
Mains AC 230 volts, 50Hz only
Back-up Battery IEC size 6LR61 (6F22,PP3)
Frequency Coverage
FM 87.5 - 108MHz
MW 525 - 1610kHz
LW 147 - 284kHz
Circuit Features
Loudspeaker 75mm diameter 8 ohms
Output Power 0.3W RMS
Aerial System FM Wire Aerial
MW Built-in Ferrite aerial
LW Built-inFerrite aerial

Guarantee
These statements do not affect the statutory rights of a consumer.
Issue 1
This radio is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component
breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced
free of charge.
The guarantee does not cover: 1. Damage resulting from incorrect use.
2. Consequential damage.
3. Product with removed or defaced serial numbers.
Procedure: Any claim under this guarantee should be made through the dealer from whom the instrument was purchased. It is likely that your
Roberts' dealer will be able to attend to any defect quickly and efficiently but should it be necessary the dealer will return the instrument to the
company’s service department for attention. In the event that it is not possible to return the instrument to the Roberts' dealer from whom it was
purchased, please contact Roberts Radio Technical Services at the address shown below.
ROBERTSRADIO TECHNICAL SERVICES
97-99 Worton Road
Isleworth Middlesex
TW76EG
Technical Helpline :- 020 8758 0338 (Mon-Fri during office hours)