ROCAM CR1015 User manual

- 02 -
- 01 -
Chapter 1 LOCATION OF CONTROLS
Power Button
Press this button to turn on radio, press it again to turn off radio.
Volume Control Knob
Telescopic Antenna
To enchance boardcast signal, you may need to plug the telescopic antenna.
Alert Flash Indicator
WX/SOS Button
Press this button to enable WX function, hold press it for more than 3 seconds to
enable SOS alert function.
Lock Switch
The lock switch prevents accidental changes of any of the radio settings. Slide
the lock switch to the position, the symbol will appear in the
display. The power and all other buttons will be disabled.
Battery Compartment
1
42
3
VOL
5
69
8
12
13
BAND
WX
SOS
14
15
7
10
11
LCD Display
Timer/Clock Set Button
Band Selection Button
Tune- Button
Tune+ Button
Speaker
Headphone Jack
Belt Clip
A removable belt clip is provided on the back of the unit.
Removal:
It can be removed by gently pushing on the center tab of the clip where
indicated, and sliding the clip down towards the bottom of the radio.
Replacement:
You can easily connect the belt clip by inserting the top of the clip into the
designated receiver slots and gently pushing the clip in an upwards motion
towards the top of the radio.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Band Indicator
Battery Life Indicator
Timer Indicator
Alert Indicator
Headphone Indicator
Lock Switch Activated
Frequence Indicator
16
17
18
19
20
21
22
AM
FM
SW
WX
KHz
MHz
ALERT
16
17
18 19 20
21
22
Emergency Radio
with AM/FM/SW/NOAA weather
CR1015
Version 1.1
ROCAM
R
Contact our experts
Mad e in China
Http://www.yelaw.net

- 06 -
- 04 -- 03 -
- 05 -
Chapter 2 BATTERY INSTALLATION
1. Gently press down the battery compartment and slide it to the right side
to open the battery compartment.
2. Insert 3pcs AAA batteries (batteries are not included), making sure the
polarity is correct.
NOTE:
A flashing appearing on the LCD display indicates a low battery
power, the replacement of a new battery is needed.
AAA batteries are not included.
Chapter 3 RADIO OPERATION
1. Turn on radio
Press button to turn on radio, radio enter FM mode or the band
you listened to last time, press butotn again to turn off radio.
2. Band
Repeatedly press button to switch from FM, Shortwave,
Weather band or AM.
Weather Band: Receives all 7 weather band from NOAA, the U.S. National Weather
Service which broadcasts in all 50 states, Puerto Rico and the U.S. Virgin
Islands.
162.400 /162.425/162.450/162.475/162.50/162.525/162.55MHz
AM Band: Receives all local AM stations from 520KHz to 1710 Khz.
FM band: Receives all local FM stations from 87.50Mhz – 108.0MHz.
SW Band: Receives all Shortwave bands from 2.3MHz- 23Mhz
BAND
WX
4. Manual Tuning Channel
Repeatedly press or button to tune into the desired channel.
Each press button, FM frequency will tune up by 0.1.
Each press button, FM frequency will tune down by 0.1.
5. Auto Scanning Radio Channel
Hold press or button for more than 2 seconds to start auto
scanning.
Scanning will stop automatically once it receive an available channel.
6. Weather Band
Repeatedly press button to select WB band until show
on the display, then Repeatedly press or button to choose
one of the WB band which is for your local weather station.
7. Weather Alert Function
Manual Setting Mode
(1) To Enable All 7 NOAA Weather Stations for Receving Alert,
press button once.
(2) When the NOAA Weather Alert function is enabled, the and
icon will show on the LCD display, the red alert light will flash.
(3) Press button to active the timer for weather alert, press
or button to set timer for weather alert, include 1H, 2H,
3H, 4H, 5H, 6H, 7H, 8H, 9H or OFF.
BAND
WX
WX
(4) Press button or wait 5 seconds to confirm the setting.
in this case, even you press button to turn off radio, the
Weather Alert function will also keep effective, but when the weather
alert timer which you set ends up, the radio will shut down
automatically .
(5) When a weather alert is received, there will be an audible siren comes
out, the red alert light, the and icon and the backlight
on the LCD display will flash.
(6) After a weather alert is received, press any button, the audible siren
will be turned off, the red alert light and the backlight will be turn off,
the and icon on the LCD will disappear. Radio will
switch to the weather channel which send weather alert
automatically.
WX
Chapter 6 SPECIFICATIONS
FM: 87.5 ~108.0MHz AM: 520~1710 Khz
SW: 2.3MHz- 23Mhz WB: USA 1-7CH with Alert
SIZE: 4.6 x 2.6 x 1.0 inch WEIGHT: 4.1oz
POWER SUPPLY: AAA Battery x 3PCS ( not included)
Chapter 5 SOS ALERT
In a emergency, you can turn on the flashing red SOS light and Alert sound.
1. Hold press Button more than 3 seconds to turn on SOS alert.
2. Press Button again, the SOS alert will be turned off.
WX
ALERT
means 1 hour means 2 hours
means 3 hours means 4 hours
means 5 hours means 6 hours
means 7 hours means 8 hours
means 9 hours
disappear that the weather alert function will always keep effective
until batteries run out or press button to turn off it.
weather alert timer
3. Volume Control
Rotate Volume knob to adjust the sound volume.
VOL
Chapter 4 SETTING RADIO SLEEP TIMER
When you are listening to AM, FM, SW or WB, you can set a timer, when the
time is up, Radio will auto turn off.
1. Press button to active the timer, symbol will appear on the
LCD display.
2. Press or button to adjust duration 90min, 60min, 45min,
30min, 15min or OFF.
OFF means that radio will alway keep effective until batteries run out or
press button to turn off it.
3. Press button or wait for 5 seconds to confirm your selection.
Other ROCAM Radio manuals