Rocket Espresso R58 User manual
Document #242894789
Removing The Housing From
Your Rocket Machine
Introduction
This instructional will cover removing the housing from your Rocket machine. This should
cover any Rocket machine you have, however, we use our Rocket R58 in this example.
Tools:
7mm wrench
Small Phillips head screwdriver
Step 1:
The first thing you want to do is
remove the reservoir cover, and
remove the reservoir itself. In the 4
corners around the reservoir, there
are the small Phillips head screws,
remove them using your Phillips
head screwdriver.
You should now be able to lift the
top panel off of the machine, it
should look something like this:
2 www.wholelattelove.com
Step 2:
Next, you will be undoing the screws on the bottom. You can either loosen these or
completely remove them. I typically choose to loosen them. If you choose to lay your
machine on the side as well, I would recommend putting a towel down so you do not
scratch or damage the sides. Use your wrench to undo the 7mm screws on the bottom.
3 www.wholelattelove.com
Step 3:
Once you’ve gotten those removed, you will need to remove the inverse screws. These
screws face inward, toward the inside of the machine. There are 2 in the back left and right
corners, and 2 in the front left or right corners. They will most likely require small micro
turns to undo them. I would not recommend fully removing these, as they required a lot
of small turns just to loosen them. You will use your 7mm wrench on these. Undo them just
enough for the panels to come apart.
The two in the back:
4 www.wholelattelove.com
The two in the front:
5 www.wholelattelove.com
Step 4:
Once you’ve gotten these
loosened, you should be
able to take the panels off
of your machine.
6 www.wholelattelove.com
Table of contents
Other Rocket Espresso Coffee Maker manuals
