Rocktron HYPNOTIC FLANGE User manual

Copyright © 2004 GHS Corporation
All Rights Reserved.
Your Hypnotic Flange™pedal has been tested and complies with the
following Standards and Directives as set forth by the European Union:
Council Directive(s): 89/336/EEC Electromagnetic Compatibility
Standard(s): EN55013, EN50082-1
This means that this product has been designed to meet stringent guide-
lines on how much RF energy it can emit, and that it should be immune from
other sources of interference when properly used. Improper use of this
equipment could result in increased RF emissions, which may or may not
interfere with other electronic products.
To insure against this possibility, always use good shielded cables for all
audio input and output connections. This will help insure compliance with
the Directive(s).
For more information about other Rocktron products, please see your local
dealer or one of our importers closest to you (listed on the Rocktron website
- www.rocktron.com).
Precautions
Read all instructions contained in this manual.
Keep these instructions
Heed all warnings
Follow all instructions.
Do not use this apparatus near water.
Clean with dry cloth

Do not block any ventilation openings (if applicable). Install in accordance with the
manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat registers, stoves or other
apparatus (including amplifiers) that produce heat.
This product is not equipped with a plug or cable. This pedal runs on a 9 Volt
Battery, if a 9Volt DC adapter is the used please follow adapter manufacturer’s
operation instructions.
Only used attachments/accessories specified by the manufacturer.
Do not use this product with any case, stand tripod, bracket or table that is not
specified by the manufacturer. Insure that the case, stand, tripod, bracket etc. is
properly adjusted and setup (follow all instructions). Extra care and caution should
be taken to avoid tip over and injury.
Unplug this apparatus during lightening storms or when unused during long periods
of time.
Refer all service to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power supply or plug is damaged,
liquid has been spilled or objects have fallen into the apparatus or if the apparatus
has been exposed to rain or moisture, does not operate normally or has been
dropped.
DO NOTATTEMPTTO SERVICE THIS EQUIPMENT. QUALIFIED PERSON-
NELSHOULD SERVICE THIS EQUIPMENT ONLY. DO NOT MAKEANY
INTERNALADJUSTMENTS OR ADDITIONS TO THIS EQUIPMENTATANY
TIME OR TAMPER WITH INTERNAL ELECTRONIC COMPONENTSATANY
TIME. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY VOID THE
WARRANTY OF THIS EQUIPMENT AS WELLAS CAUSING A SHOCK
HAZARD.
OPERATINGTEMPERATURE
Do not expose this unit to excessive heat. This unit is designed to operate between
32 F and 104 F (0 C and 40 C). This unit may not function properly under extreme
temperatures.
Precautions Continued....

Introduction
Congratulations on your purchase of the Rocktron
Hypnotic Flange.
The Hypnotic Flange offers some unique twists on the
flanger pedal. The Hypnotic Flange takes modulation to
a new level with the hypnotic mode that becomes a
random low frequency oscillator. This mode dances
anywhere from an arpeggio sound to a randomized
chorus sound. RATE controls the speed of the modula-
tion, while DEPTH controls the intensity of the modu-
lation. MANUAL control changes the modulation
delay time. FEEDBACK control varies the regenera-
tion of the modulated output. TRANCE randomizes the
low frequency oscillator, and trust us, you have not
heard anything quite like this. An FX/LEVEL control
is also provided, along with single input, mono/stereo
output.
The easy access battery compartment will make chang-
ing batteries during a gig a breeze. We have also
equipped it with a super bright blue LED so you will
know when the pedal is on...it is also just plain cool!
Enjoy

Connection 1

Connection 2

Connection 3

Controls

Rate Control - Adjusts the speed of the modulation. Turning this control
clockwise increases the speed. Turning it counter-clockwise decreases the
speed.
Depth Control - Adjusts the amount of modulation. Turning it clockwise
increases the depth of modulation. Turning it counter-clockwise decreases the
depth of modulation
Manual Control - Adjusts the modulation delay time. Turning it clockwise
increases the delay time - turning it counter clockwise decreases the delay
time.
Active LED - When lit the pedal is “active” or “on”
Feedback Control - FEEDBACK control varies the regeneration of the
modulated output. Turning it clockwise increases the feedback - Turning it
counter-clockwise decreases the feedback
FX/Level Control - Adjusts the amount of effect mixed in with the input
signal. Turning it clockwise increases the level of effect mixed with the input
signal. Turning it counter-clockwise decreases the level of effect mixed with
the input signal.
Trance Control and Hypnotic Mode Button
The Hypnotic mode is a random low frequency oscillator. This mode dances
anywhere from an arpeggio sound to a randomized chorus sound. Please see
the “Hypnotic Flange Settings” section in this manual for suggested settings.
Trance Control - randomizes the low-frequency oscillator. To engage the low
frequency oscillator press the Hypnotic mode button - point number 8.
Turning it clockwise increases the Feedback - Turning it counter-clockwise
decreases the Feedback
Hypnotic Mode Botton - Press this button to engage the low-frequency
oscillator.
1
2
3
4
5
6
7
8
Controls

DC 9V Input - To use external power (not provided) use only a 9-Volt DC
adapter
Input - Using a standard guitar cable with a 1/4” jack, plug your guitar
into this jack.
Output (Mono) Jack - When using the Hypnotic Flange in mono connect
a standard guitar cable with a 1/4” jack connect to your next effect or
directly into your amplifier.
Output (Stereo) Jack - When using the Hypnotic Flange in stereo (for
example plugging into two amplifiers) use this output jack for left side
out.
On/Off Switch - This switch determines whether the pedal is “on” or
“off” - When ON the blue LED will be lit. When OFF the LED will not
be lit.
9-Volt Battery Compartment - to access pull on small tab labeled
“OPEN”. Replace with a new 9-Volt battery. Always remember to
unplug your guitar cords from the pedal to conserve battery life. Some
battery drain may take place when unit is plugged in (even if the unit is
bypassed).
9
10
11
12
13
14
Controls Continued