Rockustics OmniPlanter 8.0 Configuration guide

H
A
N
D
C
R
A
F
T
E
D
I
N
A
M
E
R
I
C
A
H
A
N
D
C
R
A
F
T
E
D
I
N
A
M
E
R
I
C
A
R e v 7. 0 9 . 2 019
PLANTER DRIVER | INSTALL INSTRUCTIONS

PLANTER DRIVER | INSTALL INSTRUCTIONS
Please read the following instructions carefully before installing your Rockustics®Planter speaker. If you have any questions
regarding installation that are not answered in the following directions, please contact your local sound contractor or the
Rockustics®/MSE Audio®technical support team. Contact information can be found on the back of the manual.
Remove the Base
1) (Photo A) To remove the base, use a long phillips
head bit to remove the screws inside the legs that
hold the base to the Planter.
Remove the Housing
1) (Photo B) Next, remove the screws next to the
face of the driver.
Replace the Housing
1) (Photo C) Remove the old housing from the
Planter and put the wire from the new housing
through the hole in the urn.
Photo A
Photo B
Photo C

2) (Photo D) Screw the urn to the housing, pull the
new wire whip through the hole in the base.
2) (Photo E) Pull the wire tight and screw the base
back into the housing. Done.
Photo D
Photo E

Rockustics®by MSE Audio®| 10661 Rene St. | Lenexa, KS 66215
913-663-5600 or 855-663-5600 | www.Rockustics.com
Applicable Models
OmniPlanter™ 6.5
OmniPlanter™ 6.5 Transformer
OmniPlanter™ 8.0
OmniPlanter™ 8.0 Transformer
SquareRoot™ 6.5
SquareRoot™ 6.5 Transformer
SquareRoot™ 8.0
SquareRoot™ 8.0 Transformer