Rocky Mountain Westy Locking Storage Box User manual

Locking Storage Box Installation Guide
Rocky Mountain Westy Inc.
172 Spaulding Lane
Fort Collins, CO 80524
970-310-3441
www.rockymountainwesty.com

Start your installation by placing your new locking storage box in place
behind the passenger seat pedestal. Make sure you have good alignment
at the “B” pillar and where the side of the box meets the seat pillar side.

After you have double checked your box alignment, mark all the holes to
be drilled with a black marker by marking the floor and the single hole in
the “B” pillar through the mounting tabs.

Remove the box and drill all the mounting holes through the floor mat
into the wood subfloor, and the single mounting hole in the “B” pillar.
Make sure you use the correct drill bit for the mounting screws you
intend to use to fasten the box down.

Set the locking storage box back in place and install all mounting
screws through the mounting tabs into the floor and in the “B” pillar. Be
careful not to overtighten the screws.
To set your new Combi-Cam lock to your desired 3 digit combination,
simply slide a paper clip into the hole on the side of the knob while the
lock is set to all zeros. While the wire is inserted, choose your personal
combination and pull the paper clip wire out. That’s all there is too it.
If you ever want to change your combination, just enter your current
combination, slide a paper clip into the hole, select your new code and
pull the wire out.