Rompa SOUTHPAW 18891 User manual

Copyright ROMPA® Ltd
SOUTHPAW WEIGHTED SHOE POCKETS LARGE 18891, KH 5.07
SOUTHPAW WEIGHTED SHOE POCKETS LARGE 18891
CONTENTS
2 x shoe pockets (green)
(each 15.5cmL x 12.5cmW)
2 x 0.5 lb weights
(each 8.5cmL x 5.5cmW)
2 x 1 lb weights
(each 8.5cmL x 8cmW)
2 x 1.5 lb weights
(each 8.5cmL x 10.5cmW)
(weight is printed on weights)
NOTE: The Southpaw Weighted Shoe Pockets are intended to be used over shoes – shoes are
not included
TO ATTACH TO SHOES
1. Start with the Southpaw label facing the floor, with the label towards the toe of the shoe,
and the pocket towards the heel.
2. Fold the label into thirds and pass the label and webbing in between the tongue of the
shoe and the laces. It is much easier to do this with the shoe off the client. At this point the
Velcro should be facing up, and the label facing down. The pocket will look to be upside down.
3. Put the client’s shoe back on and lace it up.
4. Place the desired weight into the pocket in this inverted position. Fold the pocket over
onto the top of the shoe.
5. Fold the Velcro fastener over onto the pocket, holding it in place. If the Weighted Shoe
Pocket is too loose, release the Velcro, pull the label/Velcro towards the toe (while keeping the
pocket end held in place) and re-attach the Velcro to the pocket at a location closer to the top of
the foot.
MAINTENANCE CHECKLIST
All parts of the Southpaw Weighted Shoe Pockets should be checked on a monthly basis and a
record kept on the Maintenance Sheet provided.
•Check for loose stitching or ripped seams. If found, discontinue use till repaired.
•Check weights frequently for loose seams. If found, discontinue use immediately and
replace.
•Check the Velcro to make sure this is firmly attached. Repair if required.
IMPORTANT SAFETY ASPECTS
1. All equipment should be regularly checked. (See Maintenance Checklist above.)
2. SI equipment should never be used without professional supervision.
3. Use weight that is appropriate and comfortable for the client.
STORAGE
Store in a safe, dry place that is out of direct sunlight.
CLEANING
Please note: The weights contain steel pellets which will rust if exposed to water or excessive
moisture.
Hand wash the pockets only in a mild soap/disinfectant and water solution. Air dry thoroughly.
DO NOT wash the weights. DO NOT immerse weights in water.

Copyright ROMPA® Ltd
SENSORY INTEGRATION MAINTENANCE CHECK LIST
PRODUCT: ……………………………………………….
TO CHECK Date / S (Satisfactory) or R (Repair/replace)

Copyright ROMPA® Ltd
LISTE DE CONTRÔLE DE MAINTIEN
PRODUIT: ……………………………………………….
À SURVEILLER Date / S (Satisfaisant) ou R (Réparer/remplacer)