Ronbow MARQUEE 600718-SA Assembly instructions

INSTALLATION AND CARE GUIDE
MARQUEE FRAMELESS LED MIRROR
600718-FINISH

170728ronbow.comINSTALLATION SHEET
2
MARQUEE Frameless LED Mirror
Model : 600718-FINISH
Tools Required
MATERIALS INCLUDED
1 frameless LED mirror
1 set of z-cleat
3 wood screws
Wiring Diagram :
NOTE : ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENCED ELECTRICIAN.
WARNING: To reduce the risk of electrical shock, shut o power before wiring the mirror
CAUTION: Requires 120V 20AMP circuit.
CAUTION: The LED mirror must be wired to a 20AMP GFI (ground fault interrupter)circuit breaker
when used in bathrooms and all other locations required by the national electirc code.
120VAC
20A GFI
CIRCUIT BREAKER FIELD CONNECTION
Black = Ground
Red = Positive
White = Negative
Black = Ground
Red = Positive
White = Negative
LED
LED MIRROR CABINET
MATERIALS NEEDED
1 2 x 4 cut to size

170728ronbow.comINSTALLATION SHEET
3
MARQUEE Frameless LED Mirror
Model : 600718-FINISH
Step 1:
Figure 1.
Determine the ideal location of your new
mirror.
PRE-INSTALLATION minimum to ceiling
minimum to faucet
1”
1”
See Figure 2.
Place a 2 x 4 supporting beam behind the wall of
the desired location
Open up a hole on the wall to allow the wire
to connect to the mirror.
Step 2: Figure 2.
See Figure 1.

170728ronbow.comINSTALLATION SHEET
4
MARQUEE Frameless LED Mirror
Model : 600718-FINISH
See Figure 3.
With a leveler, mark your desire location of the
Z-cleat bracket and take the free side of the z
cleat and screw it to the wall as shown on the
right.
Step 4: Figure 3.
INSTALLING THE MIRROR
Connect the transformer connector to the mirror
then connect the wire of the mirror to the
electricity source of your home.
Then line up the Z-cleat and hang the mirror to
the wall.
Step 5: