Ronbow Taylor 602718-FINISH Assembly instructions

INSTALLATION AND CARE GUIDE
STYLE WOOD FRAME LED MIRROR
602718-FINISH

170714ronbow.comINSTALLATION SHEET
2
STYLE Wood Frame LED Mirror
Model : 602718-FINISH
Tools Required
MATERIALS INCLUDED
1 wood frame LED mirror
2 anchor
2 wood screws
Wiring Diagram :
NOTE : ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENCED ELECTRICIAN.
WARNING: To reduce the risk of electrical shock, shut o power before wiring the cabinet
CAUTION: Requires 120V 20AMP circuit.
CAUTION: The LED mirror must be wired to a 20AMP GFI (ground fault interrupter)circuit breaker
when used in bathrooms and all other locations required by the national electirc code.
120VAC
20A GFI
CIRCUIT BREAKER FIELD CONNECTION
Black = Ground
Red = Positive
White = Negative
Black = Ground
Red = Positive
White = Negative
LED
LED MIRROR CABINET

170714ronbow.comINSTALLATION SHEET
3
STYLE Wood Frame LED Mirror
Model : 602718-FINISH
Step 1:
Figure 1.
Determine the ideal location of your new
mirror. Mark the pilot hole location to
mount the mirror.
PRE-INSTALLATION minimum to ceiling
minimum to faucet
1”
1”
See Figure 2.
Drill the 5/16” pilot holes in the wall with
1-9/16” depth and place the anchors
inside the holes.
NOTE: anchors are only required when
mounting to the drywall and studs are
not available.
Open up a hole on the wall to allow the wire
to connect to the mirror.
Step 2: Figure 2.
screw
wall
anchor
See Figure 3.
Install the screw to the anchor. Leave at
least 3/16” of screw head protruding out
from the wall.
Step 3:
Figure 3.
See Figure 1.

170714ronbow.comINSTALLATION SHEET
4
STYLE Wood Frame LED Mirror
Model : 602718-FINISH
See Figure 4.
Line up the key-holes behind the mirror,
and let the mirror rest onto the screws.
Step 4:
Figure 4.
INSTALLATION THE MIRROR
Figure 5.
See Figure 5.
Connect the transformer connector to the mirror
then connect the wire of the mirror to the
electricity source of your home.
Then line up the key-holes behind the mirror and
let the mirror rest onto the screws.
Step 5:
transformer
connector