USER MANUAL 3
10) Connect dust extraction equipment. If devices are provided for the
connection of dust extraction and collecting equipment, ensure these
are connected and properly used.
11) Do not abuse the cable. Never pull the cable to disconnect it from
the socket. Keep the cord away from heat, oil and sharp edge.
12) Secure work. Where possible use clamps or a vice to hold the work.
It’s safer than using your hand.
13) Don’t overreach. Keep proper footing and balance at all time.
14) Maintain tools with care. Keep cutting tools sharp and clean for better and safer
performance. Follow instructions for lubricating and changing accessories. Inspect
tool cords periodically and if damaged have them repaired by an authorized
service facility. Inspect extension cords periodically and replace if damaged.
Keep handles dry, clean and free from oil and grease.
15) Disconnect tools. When not in use, before servicing and when
changing accessories such as blades, bits, cutters, disconnect tools
from the power supply.
16) Remove adjusting keys and wrenches. Form the habit of checking to
see that keys and adjusting wrenches are removed from the tool before
turning it on.
17) Avoid unintentional starting. Ensure switch is in “off” position when
plugging in.
18) Use outdoor extension leads. When the tool is used outdoors, use
only extension leads intended for outdoor use and so marked.
19) Stay alert. Watch what you are doing, use common sense and do
not operate the tool when you are tired.
20) Check damaged parts. Before further use of the tool, it should be
carefully checked to determine that it will operate properly and perform
its intended function. Check the alignment of moving parts, binding of
moving parts, breakage of parts, mounting and any other conditions that
may affect its operation. A guard or other part that is damaged should
be properly repaired or replaced by an authorized service centre unless
otherwise indicated in this instruction manual. Do not use the tool if the
switch does not turn it on and off.
