USER MANUAL 5
.SAFETY
- Read these instructions before operating this power tool. They contain
information which will enable you to use the tool safely and help protect
those around you.
- A copy of this instruction leaet should be kept with the tool so that you
can refer to it quickly when undertaking work. Another copy should be
made and safely away.
- The cut off machine must be put on the ground to use (Do not equip it
on the working table).
- Pay attention to the highest rotational speed limitation indicated on the
cutting wheel; do use it according to the stipulations. It’s limited to use
the glass ber reinforce cutting wheel with safety linear velocity not less
than 80m/s. It’s forbidden to use any other grinding cutting disk.
- Do check if there’s any ssure or damage situation of the cutting wheels
before using the machine every time. If there’s such situation, it must
be replaced to avoid any accidents
- Do equip the cutting wheel according to the operation explanations, use
wrench to x the cutting wheel carefully, it’s possible to occur dangers
if equips too loose; and it’ll damage the cutting wheel if equips too tight.
- Key factors of inspection in trial operation:
- Check the cutting wheel rstly to conrm its model is conforming to
the requirements of the machine type; the cutting wheel is in good
and complete condition. At the time of starting up the machine, don’t
touch the materials, to ensure it’s starting up under idling condition.
In trial operation, please keep a little far away from the machine to
avoid any possible accidents.
- Please close the current source at once if the cutting wheel stops,
gives noises or vibrates.
- The processing project must be clamped tightly, or it’s possibly to
occur dangers due to the dithering of the project: Make use of the silk
rod handle and plier’s plate to clamp the object tightly, hinge on the
base plate and graduation plate to make processing.
- Please note if the machine is equipped in level, the cushion block can
