Room essentials L-GZ375PST-3 User manual

Room Essentials
RE 9x9' Gazebo w/ Mosquito Net
Style # L-GZ375PST-3
DPCI # 009-05-0211
>> Assembly Instruction
Production Number: XXXXXXXX

Warning
1. When assembling and using this product, basic safety precautions should always be followed to reduce the risk of personal injury and damage
to equipment. Please read all instructions before assembly and use.
2. Some parts may contain sharp edges, wear protective gloves if necessary. At least four or more people are recommended for safe assembly.
3. Keep all children and pets away from assembly area.
4. Begin assembly not less than 6 feet from any obstruction such as fence, garage, house, overhanging branches, laundry line or electrical wires.
5. Install on level ground. This gazebo cannot be permanently staked or attached to concrete floor or platform. This gazebo is intended for
decorative and sunshade purposes only and is not meant to withstand inclement weather including high winds, rain and snow. Gazebo fabric
is water resistant, not water proof and may leak during exposure to precipitation.
6. Check all nuts and bolts for tightness before and during usage.
7. Keep all flame and heat sources away from this gazebo fabric. This gazebo is made with fabric that meets CPAI-84 specifications for flame
resistance. It is not fire proof. The fabric will burn if left in continuous contact with any flame source. The application of any foreign substance
to the gazebo fabric may render the flame-resistant properties ineffective.
Tools Needed
>> Assembly Instruction

Hardware Pack 1
AA× M6*4B
H02015C11 H02025C11 H02035C11 H19001C11
H14001C11 H00001C12 P12401A01001 P90701A07106
olt BB×32 M6*30 Bolt CC×8 M6*35 Bolt DD×52 M6 Flat Washer
EE×8 M6 Nut FF×1 M6 Wrench GG× ¢6*180 Stake HH×32 Mosquito Netting Hook
>> Assembly Instruction
4
12

Part List
>> Assembly Instruction
A Top connector P10101B01108
1
BLong oblique beam 4
CShort oblique beam 4
D Girder 4
EHorizontal beam 1 4
FHorizontal beam 2 4
G Connector 4
HPole 4
J Arc connector 4
K Hook 1
L Small Canopy 1
M Large Canopy 1
N Mosquito Netting
P10301B01168
P10732A01108
P10470A01108
P11035C01108
P11036C01108
P11474A01108
P11138B01108
P11880A01108
P12601A01108
P00144B06001
P00146B06001
P00326B019021

>> Assembly Instruction
Step1
Fig.1:
Insert one side of
horizontal beam1
(E) into horizontal
beam 2 (F).
Fig.2:
Insert another side of
horizontal beam 1(E)
and horizontal beam
2 (F) into the hole of
connector (G)
Fig.3:
Connect short oblique
beam (C) and
connector (G), then
tight by Bolt (CC),
M6 Flat (DD)
and M6 Nut (EE).
Fig.4:
Insert hook (K) into
top connect (A) first,
then Insert long
oblique beam (B) and
one side of girder (D)
into top connector
(A).
Fig.5:
Insert one side of
long oblique beam (B)
into short oblique
beam (C).
Fig.6:
Using bolt (CC),flat
washer (DD) and nut (EE)
to connect girder (D) and
horizontal beam 1 (E), then
Lock with tight.
Fig.3
DD
CC GC
DD EE
Fig.6 D
DD
EEDD
CC
E
Washer

Step2
Fig.8:
Left assembled parts(G)
up, connect connector (G)
and pole (H) by using
bolt (AA), flat washer
(DD).
Fig.9:
Connect one side of arc
connector (J) with pole (H),
and connect the other side
with horizontal beam
1(E) and horizontal beam
2(F).
Fig.7:
Finish covering small canopy (L), cover
big canopy (Q), do not fully cover.
DD G
H
AA
Fig.8
Fig.9
JH
DDDD
BB
BB
Fig.7
Fig.8
Fig.9
M
L
H
J

Step3
Fig.10:
Using mosquito netting Hook
(HH) to hang mosquito
netting (N) into horizontal
beam 1(E) and horizontal
beam 2(F).
Fig.11:
Attached the mosquito
Fig.12:
Fixed Netting on the pole
botton with string.Refer to
picture
netting (N) to the pole (H).
Fig.13:
Put Big canopy (M) over.
Fig.14:
Attached stake (GG) to
Pole (H) on the ground,
then finish all the assembly
steps
Fig.13
M
Fig.12Fig.11 Fig.14 Fig.10
GG
H
Fig.12
Fig.10
Fig.11
Fig.13
M
N

USE:
1. This sun shelter is not a permanent structure and should be disassembled & stored away after use.
2. Do not repack your sun shelter until completely dry.
3. This sun shelter must be assembled by two adults or more.
4. This sun shelter must not be left erect in windy conditions.
5. KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS GAZEBO FABRIC.
6. This Gazebo is made with fabric that meets CPAI-84 specifications for flame resistance. It is not fire proof.
The fabric will burn if left in continuous contact with any flame source. The application of any foreign substance
to the gazebo fabric may render the flame-resistant properties ineffective.