Ropox 30-69 8 Series User manual
Keep this folder with product at all times!
PDF 5938 / 01.10.2010
Do not bend or break the Safety strip!
Mounting of safety strip
* Option: Ropox always recommends the use of safety strips for electrically
operated frames.
Be careful not to damage the safety strip during transport or mounting.
If the safety strip is attached to an uneven or curved surface, whereby it is
bent or distorted, the correct functioning of the safety strip may be
jeopardised.
The surface to which the safety strip is to be attached must be clean, dry
and degreased to obtain optimum adhesion.
Please use provided cleansing tissue
The ”corner guides” should be mounted first as a guide for the safety strip. They
should be placed where the side facia and front fascia meet.
Mount the safety strip on the bottom side of the fascia by means of the double adhesive
tape starting at the furthest point from the control box.
Remove the protective paper of the tape and press on the safety strip. Be aware of the
minimum inside bending radius R
min
=2 cm.
Pull out the red resistor plug (E) from the short cable (A) (marked with red tape).
Connect the plug from the safety strip (D) with the available male plug (A).
A:
Short cable for downward movement (Red)
B:
Long cable for upward movement (Yellow)
C,E:
End plug with resistor (Red)
If there is no end plug with red resistor (C) mounted at
(B), the frame will not work in the upwards direction.
See also manuals for Flexi.
(A) connects to safety strip (D)
Mounting of safety strip onto 4Single:
Do NOT pull safety strip too hard when pushing through leg section of 4Single!
Please also note 4Single user manual
B
A
C
E
IMPORTANT
Mounting of safety strip
5.
Shorten the Safety strip
6.
Connect the end plug
1 cm
D
A
7.
R
Radius R
min
=2cm
Corner
1. START
2.
3.
4.
D
Sectional view of wooden front fascia / side
fascia:
It is extremely important to mount safety strip in
straight line with edge of front fascia / side
fascia.
Safety strip overview
30-69XXX Safety strip L=XXX cm, incl. 150cm cable with plug
XXX XXX XXX XXX XXX XXX XXX XXX XXX XXX XXX
Cm 56 120 160 200 240 280 320 420 520 620 820
Mounting parts;
Corner guide 97701-624 3 pcs.
End plug with 1,2 Kohm resistor 1 stk.
Knife 97004020 1 stk.
Tissue, VHB Surface Cleaner 97002939 1 pc.
Options for the safety strip
Extension cord for safety strip 30-67870: 1 pc.
L=250 cm (black)
Spiral extension 30-67871: 1 pc.
L=25-100 cm (black) for safety strip
General info:
Ropox always recommends the use of safety strips at three sides of the electrically
operated Flexi frames.
Safety strip to be supplied in fixed lengths (see above). All safety strips are supplied with
150cm cable with plug.
End plug with resistor supplied loose, to be able to shorten the safety strip to suitable
length.
Ex. – Worktop length + 2 x 58 cm = length of safety strip, for worktop depth 62 cm.
It is not possible to connect several safety strips in a row.
The safety strip will take over for old safety stop rails (for Flexi electrical version -8).
ROPOX A/S
Ringstedgade 221
DK – 4700 Naestved
Tel.: +45 55 75 05 00 Fax.: +45 55 75 05 50
www.ropox.com
This manual suits for next models
1
Table of contents
