a
a
e
bb
b
cc
d
SETTING UP YOUR PRODUCT
NEED ASSISTANCE? Customer Service Support: 847-763-1215
Address: 3714 Jarvis Avenue Skokie, IL 60076
Website: www.rosseto.com
Avant Guarde™ Tabletop Divider
Instruction & Specication Sheet
1. Carefully remove all parts from packaging.
2. Make sure you have all parts listed according to your model:
3. To assemble, insert L-Bracket (a) into Bracket Housing (b) at an angle as shown in Figure 1. If part is already assembled,
simply loosen the L-Bracket (a) by unscrewing the bottom screw (c) with M2.5 Allen Key.
4. Place Bracket Housing (b) on the edge of table. Push L-Bracket (a) up against the bottom of the table as shown in Figure
2. While clamping the Bracket Housing (b) and L-Bracket (a) against table, tighten the bottom screw (c).
5. Repeat with other bracket if applicable.
6. Loosen top screw (e). Place Acrylic Panel (d) inside the Bracket Housing (b) and tighten top screw (e) as shown in Figure 3.
7. Be careful as to not over-tighten the screws.
8. Use the Cross Connector (f) to attach additional panels together as shown in Figure 4.
Figure 1 Figure 2 Figure 3 Figure 4
f
• TD001 - 4 Acrylic Panels & 8 Cross Connectors
• TD002 - 4 Acrylic Panels & 8 Cross Connectors
• TD003 - 2 Acrylic Panels, 2 Stainless Steel Brackets & 4 Cross Connectors
• TD004 - 2 Acrylic Panels, 2 Stainless Steel Brackets & 4 Cross Connectors
• TD005 - 1 Acrylic Panel & 2 Stainless Steel Brackets
• TD006 - 1 Acrylic Panel & 2 Stainless Steel Brackets
• TD007 - 1 Acrylic Panel & 2 Stainless Steel Brackets
• TDK001 - 3 Acrylic Panels, 4 Stainless Steel Brackets & 2 Cross Connectors
• TDK002 - 3 Acrylic Panels, 4 Stainless Steel Brackets & 2 Cross Connectors
• TDK003 - 7 Acrylic Panels, 8 Stainless Steel Brackets & 6 Cross Connectors
• TDK004 - 7 Acrylic Panels, 8 Stainless Steel Brackets & 6 Cross Connectors
• TDK005 - 7 Acrylic Panels, 8 Stainless Steel Brackets & 6 Cross Connectors
