
TOOLS NEEDED FOR ASSEMBLY
(1) Unscrew the pre-assembled lock nut and flange nut from the
threaded pin of the cast iron burner . Then insert the threaded pin of
burner through the hole of the support bar of stove stand.
(2) Insert the heat shield onto threaded pin of the burner then screw
with a M6 flange nut and a M6 lock nut.
*Make sure all hardware are used and tightened with wrench.
Note: When connecting the Hose to unit, insert
the male fitting of the hose. Tighten the fitting
onto the throat of the burner using a wrench.
Do not overtighten. You should be able to turn
the air control panel.
1. Place stove on a level, stable surface.
2. Attach propane hose to the brass stove inlet fitting.
3. Make sure propane bulk tank valve is closed.
4. Attach propane hose to outlet of propane tank.
5. Slowly open propane tank valve and check for leaks by applying
small amount of liquid soap and looking for bubbles to appear.
1. Read instruction before lighting.
2. When you are sure there are no leaks, turn cylinder valve and regulator control valve on hose to the closed position.
3. Have a fireplace match or long-nosed lighter lit and over the burner from SIDE. Keep hands and face away from burner.
4. Slowly open gas supply until burner ignites. Keep hands and face away from burner.
5. Adjust the regulator control valve for desired flame height.
6. When finished using the cooker, turn off gas cylinder valve first. lt will take a few seconds for the fire to go out and for the propane
gas to bleed from the hose and regulator assembly. After the fire is completely out, turn regulator control valve to the OFF position.
7. To re-light, repeat steps 1-6. Always use CAUTION as cooker will be hot.
8. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat the lighting procedure.
Counter clockwise to
open the gas supply
1. DO NOT leave propane tank attached to stove during storage or transport.
2. Wipe the burners, steel cooking grate, and propane hose before storing.
3. It is suggested to store stove and hose in a nylon storage bag to keep it clean.
DO NOT attempt to connect your camp stove to a natural gas supply. Use only
with propane, hose and regulator supplied with the stove and an approved bulk
propane tank.
The warranty period of the product is 365 days from the date of purchase. If the product has any problem, please feel free to reach
out to us and we will work out solutions for you ASAP. And please include the order number in the email
when you contact us so that we can get the order and product info and help you resolve the issue faster.
If you have any questions, please contact us at support@rovsun.com