Rowenta Air Force Flex 560 Installation guide

FAQ
Your device stops during operation and the light/s flash very quickly.
Your device may be overheating.
Turn the device off and let it cool for at least 1 hour.
If the problem persists, contact Customer Service.
The charger is connected but your device is not charging.
The charger is not properly connected to the device or is faulty.
Check that the charger is properly connected or contact an Approved Services Centre to change
the charger.
The device has stopped after the charge light flashed.
The device is discharged, please recharge it.
The charger becomes hot.
This is perfectly normal. The vacuum cleaner can remain permanently connected to the charger
without any risk.
The power-brush stops during use of the vacuum cleaner.
The heat safety device has triggered.
Stop the vacuum cleaner. Check that nothing is obstructing the rotation of the brush. If there is
an obstruction, remove it and clean the power-brush, then turn on the vacuum cleaner.
Your vacuum cleaner suction is not working properly or is making a whistling noise.
• The tube or hose is partially blocked: unblock them.
• The dust collector is full: empty it and clean it.
• The dust collector is not properly fitted: re-position it correctly.

• The suction head is dirty: remove the power-brush and clean it.
• The foam motor protection filter is full: clean it.
The power-brush is not working properly or makes a noise.
• The rotating brush or hose are obstructed: stop the vacuum and clean the parts.
• The brush is worn: contact an Approved Service Centre to change the brush.
• The belt is worn: contact an Approved Service Centre to change the belt.
When charging the vacuum cleaner, the light(s) flash very quickly.
The correct charger is not being used or the charger is faulty.
Talk to an Approved Service Centre to change the charger.
What should I do if my appliance is not working?
After following the instructions in the user manual for starting the appliance, make sure that your
electrical socket is working by plugging another appliance. If it still does not work, do not try to
dismantle or repair the appliance yourself and take it to an approved repair centre.
What should I do if the power cord of my appliance is damaged?
Do not use your appliance. To avoid any danger, have it replaced by an approved repair centre.
Why is my vacuum cleaner's performance going down?
Check the filter, if it is in bad condition, change it.
Empty the dust container.
Check the brush condition and refurbish or change it if necessary.
Why is the autonomy of my vacuum cleaner decreasing?
Check that the battery is fully charged after a complete charging cycle.
If the battery is faulty, please replace it.