Rowlinson Garden Products Bali set User manual

Bali set table assembly
Assembly Instructions
English SS262
No. Components Qty.
1 Table top 1
2 Table top extension 1
3Legs 2
4 Leg brace 1
5 Extension support 1
6 Leg corner supports 6
Before assembly
•We recommend that time is taken to
read the instructions before starting
assembly, then follow the easy step by
step guide. The instruction sheet is only
a guide to the assembly.
Certain items may not be shown
to scale.
•Check all components prior to assembly
•This product should be assembled
by no less than 2 people
No. Fixing kit Qty.
7 90mm screws 4
8 60mm screws 8
9 40mm screws 16
10 Dowels 4
11 Allen key 1
Recommended tools for assembly
•Allen Keys (supplied with kit)
•Cross head screw driver
2010 © Rowlinson Garden Products Ltd
If in doubt of any aspect regarding the assembly, use or safety of your furniture set please contact us :
Help Line (Normal Office Hours) 01829 261 121
ROWLINSON GARDEN PRODUCTS LIMITED
Green Lane
Wardle Nr. Nantwich
Cheshire
CW5 6BN
We constantly improve the quality of our products, occasionally the
components may differ from the components shown and are only
correct at time of printing. We reserve the right to change the
specification of our products without prior notice.
x 2
1
2
3
4
56
5. Operating the table extension
Fold the table extension into the middle of the table. Push the two table top sections together until they meet in the
middle. Table position should be secured using the latches on the underside of the table.

1. Leg braces
Join the 2 legs together using the leg braces as shown below. Secure the using 2 x dowels and 2 x 90mm screws at each
end, slot in the dowels and screw through the pre-drilled holes of the legs into the brace.
2. Table top extension
Seat the table extension into position on the table top and secure to the table frame using 2 x 60mm as shown. Secure the
extension support in the position shown using 2 x 60mm screws
90mm
90mm
60mm
60mm
60mm
60mm
3. Legs to table top
Position the leg assembly onto the table assembly as shown. Secure using 4 x 60mm screws, screw through the pre-drilled
holes of the legs into the framing of the table assembly.
4. Leg corner supports
Position the 4 leg corner supports as shown and secure through the pre-drilled holes using 4 x 40mm screws per corner
support.
40mm
60mm