How to use the Transfer Bench
Place the two legs of the bench on the handled side into the bath.
When transferring onto the bench, stand with the back of your legs against the side of the bench as
close to the bath as possible, and firmly place each hand on the seat, if appropriate, to ensure your
body is supported and the bench is stable. Then slowly lower yourself down to sit on the edge of the
bench.
Using the support of the transfer bench handle, turn your body and slowly lift your legs over the
bath walls until both legs are in the bath, this can be done by lifting one leg at a time. Use the
transfer bench handle and the front of the seat to slide yourself across the bench until you are
seated in the middle of the bath.
When getting off the bench, using the arm rest and front of seat, slide across away from the bath.
Slowly lift legs over the bath wall and position yourself on the edge of the bench with your legs
close to the bath wall.
Bring your bottom to the front of the seat ensuring your feet are firmly placed flat on the floor. Place
your hands on the seat of the transfer bench, if appropriate, to push yourself into standing leading
with your head and shoulders.
Adjusting the Height
To adjust the leg length, press the button in and slide the leg piece up or down to the appropriate
notch. Your Occupational Therapist can best advise regarding the appropriate height.
Independent Living Specialists PTY LTD
Unit 1 /12 Mars Rd,
Lane Cove NSW 2066
1300 008 267
ilsau.com.au
S11190
