RS PRO 178-5735 User manual

①
Opening the cover: Pinch the two hooks inwards
and lift, the cover will open.
Status Indicator: On, the printer is on-line.
Off, the printer is off-line.
LF button: Line feed. Hold down the FEED button, paper
feeding begins.
Panel cut-out size: 103 +0.5
0*57+0.5 0
Communication interface
Power socket
Step 1: Insert printer in the equipment panel and install
the fixing clips into the grooves, then tighten each
screw。
Equipment Panel
Fastening clip
Data cable
PDK power cable
Printer
https://uk.rs-
online.com/web/c/power-supplies-
transformers/power-supplies-
psus/din-rail-panel-mount-power-
supplies/?sra=p&applied-
dimensions=4294965625,4294430
481,4294875343

②
①
To change the ribbon open the upper cover and pull out the
cassette, then insert the new cassette and close the upper
cover.
Upper cover
Cassette
Please open upper cover from here
Step 2: Insert power and data cables securely.
The installation is finished.
Pinch both locking tabs inwards and lift cover

②
③
④
Step 3: Install the new paper roll with the paper reel in the
direction shown in the illustration into the roll holder and close
the retainers.
Pinch both paper roller tabs to remove
the empty paper roller (if installed)
Paper roller
Paper reel
Wrong direction.
Step 4: Switch on, press the feed button and feed the
paper through the feed port. Stop the feed when
sufficient paper protrudes from the port.

⑤
Step 5: Close the cover to complete the paper
installation.
Note 1: If the paper roll is loose it may be difficult to
install or may jam. Ensure the roll is tightly coiled
before installation
Picture 1
Note 2: If you cannot close the door do not try to
force it. Remove the paper roll and start the
installation procedure again
Note 3: After installation avoid hard shocks or high
vibration to avoid damage and ensure correct
operation and long life.