RSI HA1002 User manual

If mounting on machine without cross bar using grab bar, please see instructions with mount kit (HA1002).
TOOLS REQUIRED:
12mm wrench
4mm Allen wrench
Step 1: install Jam nuts on grab handle finger tighten until nut is flush with rubber handle (Do not use wrench or over tighten)
Step 2: Install grab bar into Grab Bar mounts spin on until bottomed out and minimal thread is exposed.
Step 3: Remove bottom caps from Grab bar mounts, install grab bar on handlebars. Grab bar mounts can be
orientated towards the bar pad or away from bar pad depending on application (see last pictures of instructions). Finger
tighten bottom cap of grab bar mounts.
Finger tighten until jam nut is
flush with rubber (Do not use
wrench or over tighten)
Repeat on opposite side
Minimal thread should be
showing

Step 4: Using 12mm Wrench tighten Jam nut on to grab bar mount
Step 5: Align grab bar and tighten bottom caps of grab bar mounts using 4 mm Allen wrench
LIMITED WARRANTY
RSI Racing warrants this product to be free from defects in material and workmanship under use for the purpose it was intended.
RSI Racing shall not be liable for damage or injury caused by defective materials or workmanship. RSI Racing may elect to repair or
replace this product, but RSI Racing is the sole judge of any defects in their product. This warranty does not cover any labor costs to
remove or reinstall this product and is effective for one year from the original purchase date.
RSI Racing 15250 Hornsby St Forest Lake, MN 55025 208-994-6413 www.rsiracing.com