Rugged Radios RRP6100 User manual

Rugged Radios | www.ruggedradios.com | 888-541-7223
1. DRIVER VOLUME Controls driver volume
2. DRIVER ISOLATE Controls Driver Isolate function
3. POWER/TX Blue indicates power is on. Red indicates transmitting
4. SIDE TONE Controls Side Tone function
5. CO-DRIVER VOLUME Controls co-driver volume
RRP6100
USER MANUAL
INTERCOM OPERATION
Power On/O
Turn the Co-Driver Volume pot clockwise. You should feel a click and the intercom’s LED
in the center should illuminate Blue.
Volume Control
Volume control is independently controlled for Driver and Co-Driver.
The left knob controls Driver listening volume and the right knob controls Co-Driver’s listening volume.
Sidetone Switch
This function allows the users to hear themselves in their own helmets or headsets. This helps users
modulate their actual speaking volume to prevent unnecessary yelling into the mic. Switch position
up to activate and down to turn o.
Driver Isolate Switch
In the on position, all radio trac is heard by co-driver only so the driver can concentrate
on driving. Both Driver and Co-Driver can transmit while this function is on.
PTT Function
Each PTT activates only one headset mic at a time. Driver PTT will activate the mic in the Driver
headset port and will not activate the Co-Driver headset port mic. The Co-Driver PTT activates
only the Co-Driver headset port mic. If during transmission you aren’t transmitting your voice at all
or it is extremely quiet make sure you didn’t accidentally plug into the wrong headset port or plug
in your PTT buttons in the wrong position.
1 2 53 4

CO-DRIVER
HEADSET
DRIVER
PTT
HEADSET
PTT
RADIO AUX
RADIO GAIN
INSTALLATION GUIDE
RR6100
Rugged Radios | www.ruggedradios.com | 888-541-7223
This is a universal wiring diagram. Your exact configuration might vary depending on the system purchased.
HEADSETS connects driver headset or
helmets to intercom. Route away from
power and antenna cables.
RADIO connects to optional radio.
POWER connect +/- directly to
12v battery.
Connect Power
• Route all power cables directly to the battery.
• DO NOT connect inline with other components. If
power is tied to ignition, lights or other power sources,
a ground loop problem may occur, causing noise in the
system.
• DO NOT remove any fuses that are in line with factory
cables or otherwise modify power cables.
Radio & Intercom Mounting
• Both the intercom and radio come with universal
mounting brackets. Vehicle specific mounting
options are sold separately.
• DO NOT mount the radio or intercom near an
ignition box to avoid RF interference.
• Route antenna cable away from power leads.
PTT connects Push to Talk buttons for
use with 2-way radio. Pay attention to
route driver and co-driver PTT to their
corresponding seat position.
PTT PTT
HEADSET HEADSET
RADIO
AUX AUX allows in/out connectivity to
cell phones, audio recorders, GoPro,
and other devices with optional cables.
If using optional Active Filter, connect
radio and intercom power leads directly
to Audio Filter and NOT to the battery.
ACTIVE
FILTER
ACTIVE FILTER