CLEANING AND MAINTENANCE
1. Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator
frequently. When cleaning, unplug the unit and remove the ice cubes. Use a
diluted solution of water and vinegar to clean the inside and the outside surface
of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such
as acids, gasoline or oil. Rinse thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in structure,
clear of obstruction. Do not use mechanical devices or other means to accelerate
the defrosting process, other than those recommended by the manufacturer.
3. To ensure the cleanness of ice, please change water for water reservoir at least
once one day. If do not use for a long time, please drain the water out and clean
it up.
4. If the compressor takes a strike action for shortage water, fully water or
interruption of power supply, it will delay for 3mins to start up after restarted.
5. Always use fresh water before starting ice production either at initial installation
or after a long shut-off period.
STORING THE APPLIANCE
•Unplug the unit from the wall outlet and clean all the parts as instructed above.
Ensure that all parts are dry before storing.
•Store the appliance in its box or in a clean, dry place.
•Never store the appliance while it is still wet or dirty.
•Never wrap the power cord around the appliance. Do not store the appliance with
the thermostat control/ probe inserted in the unit, always unplug it. Ensure the
thermostat control/ probe is stored in a safe place where it will not be dropped,
bumped or damage
