Russell Hobbs RHCV21 Installation guide

INSTRUCTIONS AND WARRANTY
MODEL NO. RHCV21
DESCRIPTION
Congratulations on purchasing our RUSSELL HOBBS ALL CLEAN VACUUM. Each unit
is manufactured to ensure safety and reliability. Before using this appliance for the first
time, please read the instruction manual carefully and keep it for future reference.

2
FEATURES OF THE RUSSELL HOBBS ALL CLEAN VACUUM
IMPORTANT SAFEGUARDS
When using any electrical appliance, basic safety precautions should always be followed
including the following:
1. Please read the instructions carefully before using any appliance.
2. Always ensure that the voltage on the rating label corresponds to the mains
voltage in your home.
3. Incorrect operation and improper use can damage the appliance and cause injury
to the user.
4. The appliance is intended for household use only. Commercial use invalids the
warranty and the supplier can not be held responsible for injury or damage
caused when using the appliance for any other purpose than that intended.
5. Avoid any contact with moving parts.
6. Close supervision is required when any appliance is used near or by children or
invalids.
7. Check the power cord and plug regularly for any damage. If the cord or the plug
is damaged, it must be replaced by the manufacturer or a qualified person in
order to avoid an electrical hazard.
8. Do not use the appliance if it has been dropped or damaged in any way. In case
of damage, take the unit in for examination and/or repair by an authorised service
agent
9. To reduce the risk of electric shock, do not immerse or expose the motor
assembly, plug or the power cord to water or any other liquid.
10. Never immerse the unit in water or any other liquid for cleaning purposes.
11. Remove the plug from the socket by gripping the plug. Do not pull on the cord to
disconnect the appliance from the mains. Always unplug the unit when not in
use, before cleaning or when adding or removing parts.
12. The use of accessory attachments that are not recommended or supplied by the
manufacturer may result in injuries, fire or electric shock.
13. A short cord is provided to reduce the hazards resulting from becoming
entangled in or tripping over a longer cord.
14. Do not let the cord hang over the edge of a table or counter. Ensure that the cord
is not in a position where it can be pulled on inadvertently.

3
15. Do not allow the cord to touch hot surfaces and do not place on or near a hot gas
or electric burner or in a heated oven.
16. Do not use the appliance on a gas or electric cooking top or over or near an open
flame.
17. Use of an extension cord with this appliance is not recommended. However, if it
is necessary to use an extension lead, ensure that the lead is suited to the power
consumption of the appliance to avoid overheating of the extension cord,
appliance or plug point. Do not place the extension cord in a position where it can
be pulled on by children or animals or tripped over.
18. This appliance is not suitable for outdoor use. Do not use this appliance for
anything other than its intended use.
19. DO NOT carry the appliance by the power cord.
20. Do not leave this appliance unattended during use. Always unplug the unit when
not in use or before cleaning.
21. Always operate the appliance on a smooth, even, stable surface. Do not place
the unit on a hot surface.
22. Ensure that the switch is in the “Off” position after each use.
23. Do not pick up anything that is burning or smoking, such as cigarettes, matches,
or hot ashes.
24. Do not use without dust bag and/or filter in place.
25. The manufacturer does not accept responsibility for any damage or injury caused
by improper or incorrect use, or for repairs carried out by unauthorised
personnel.
26. In case of technical problems, switch off the machine and do not attempt to repair
it yourself. Return the appliance to an authorised service facility for examination,
adjustment or repair. Always insist on the use of original spare parts. Failure to
comply with the above mentioned pre-cautions and instructions, could affect the
safe operation of this machine.

4
PARTS DIAGRAM
Floor Brush
Extention
Tube
Dust Compartment
Subassembly
Base Body
Handle and
Cable Rewind Botton
Hose
On/Off Switch

5
PRECAUTIONARY MEASURES
If the opening that sucks in the air, the suction pipe or the telescopic wand on
pipe are blocked, you should switch off the vacuum cleaner at once. First clear the
blocked substance before you attempt to start the vacuum cleaner again.
1.Do not operate the vacuum
cleaner too close to heaters,
radiators, cigarette
butts etc.
2. Before you insert the plug
into the wall contact, make
sure your hand is dry.
3. Before you start using the
vacuum cleaner, please remove
large or sharp objects from the
floor in order to prevent damage to the
filters and unit.
4. When you want to pull the plug
from the wall contact, please do
this at the plug itself and not by
means of the electrical cable.
This vacuum cleaner is equipped with a plug and a cable, which rolls up automatically.
If anything gets damaged, both the plug and the cable must been repaired by a
qualified repairman or electrician.

6
OPERATING INSTRUCTIONS
Always remove the plug from the power socket before fitting or removing accessories!
I. Connecting vacuum cleaner
1. Fitting or removing the flexible hose
Fitting:
Insert flexible hose into the air intake duct on
the top of appliance. Press until it clicks into
position.
Removing:
Removing the plug from the power socket. To release the flexible hose firmly pull
from the air intake duct.
2. Fitting the extension tubes and accessories
a. Fitting the extension tube to the handle.
b. Fitting the extension tubes.

7
II. Cleaning tools use
The crevice tool and dusting brush are stored on the accessories holder.
1. Crevice tool:
For radiators, crevices, corners, baseboards and between cushions.
2. Dusting brush is used for the furniture, blinds, bookshelves,
lamp shades and shelves.
INSTRUCTIONS FOR USE
Before using appliance, unwind a sufficient length of cable and insert the plug
into the power socket. A yellow mark on the power cable shows the ideal cable
length. Don’t extend the cable beyond the red mark.
1. Press the ON/OFF button to switch the appliance on.
2. To rewind the power cable, press the rewind button with one hand and
guide the cable with the other hand to ensure that it does not whip causing
damage.
Yellow
Red
On/Off Switch
Cable Rewind Button

8
MAINTENANCE
1. Emptying rubbish from the dust compartment
Always operate the cleaner with the dust compartment subassembly installed.
If you forget to attach HEPA and filter or attach it in the wrong manner, this may
cause damage to the dust compartment subassembly.
2. Cleaning and changing filter or HEPA
Filter for air-inlet should be cleaned at least monthly or when it becomes visibly
solid.
Clean HEPA for air-let monthly or when you find it is completely full.
Always operate the cleaner with filters and HEPA installed.
Otherwise, reduced suction or motor damage may be result.
Disconnect from electrical outlet, before cleaning filter.
Do not use a washing machine to rinse filter.
Do not use hair drier to dry it.
3. Cleaning and changing filter and HEPA for air-inlet
(1) Take out HEPA assembly.
(2) Rinse bracket and HEPA in lukewarm water and dry Filter and HEPA
completely.

9
(3) Take out Filter grill.
(4) Rinse Filter grill in lukewarm water and dry it completely.
(5) Put the Filter grill into the Front cover for dust cup, then put HEPA into the
front cover for dust cup or change new HEPA.
4. Changing filter for air-outlet
(1) Open the grille for air-outlet.
(2) Open the grill for the air-outlet to find the filter for the air-outlet.
(3) Take the filter out and rinse gently.
(4) Close the grille for air-outlet.

10
CLEANING AND MAINTENANCE
This appliance is for household use only and is not user-serviceable.
Do not open or change any parts by yourself. Please refer to a qualified electrical
service department or return to the supplier if servicing is necessary.
Always remember to unplug the unit from the electrical outlet when not in use
and before cleaning. Ensure that the speed control is set to “0”.
It is much easier to clean the accessories directly after they have been used.
Wash them in warm, soapy water, rinse and dry well.
The body of the appliance and the stand should be cleaned with a damp cloth.
Do not let water enter the appliance or the stand.
Do not use bleach or other abrasive substance or solvents to clean your
appliance as it can be damaging to the finish.
Do not immerse the mixer in water or any other liquid, or hold it under a running
tap to clean.
To remove stubborn spots/marks, wipe the surfaces with a cloth slightly
dampened in soapy water or mild non-abrasive cleaner. Rinse and dry a clean,
dry, soft cloth.
STORING THE APPLIANCE
Unplug the unit from the wall outlet and clean all the parts as instructed above.
Ensure that all parts are dry before storing.
Store the appliance in its box or in a clean, dry place.
Never store the appliance while it is still wet or dirty.
Never wrap the power cord around the appliance.