Russwood STATELY RADIUS SHELVING UNIT User manual

STARTER & ADDER ASSEMBLY
RADIUS SHELVING UNITS - STATELY SERIES
ASSEMBLY INSTRUCTIONS FOR 36”,42”,48”,60”
Tools needed: 1/2” box
wrench and 1/2” socket wrench,
and phillips Head Screwdriver.
(Power drill recommended)
NOTE: Partitions slide in from the bottom of the units, so it is easiest to assemble the shelving upside down
NOTE: Intermediate Panels will not have threaded barrel inserts, but will have
holes that go all the way through the panel to allow adder bolts to pass through.
Prepare all STARTER panel
bolts with washers AND lock
washers.
Align the top frame edges with the edge
band lines on the Upright/End Panel. Use
the 1/2” wrench to tighten each bolt slowly.
Top frame can be lightly tapped with your
hand to maintain alignment during tight-
ening. DO NOT over tighten panel bolts.
e bottom frames also have blocks with holes that will be lined
up with the threaded barrel inserts found in the Upright/End
Panel. Pass bolts with washers (as pictured in step 2)
through the bottom frame blocks and HAND TIGHTEN. Once
all bolts are hand tightened, wrench tighten all bottom frame bolts.
Line up the top frame block holes with the barrel inserts found in the top of the Upright/End Panel. Pass bolts
with washers through the top frame blocks and HAND TIGHTEN the bolts.
TOP OF UPRIGHT /
END PANEL - Indicated with
single barrel inserts.
TOP FRAME
BOTTOM
FRAME(S)
BOLTS &
WASHERS
UPRIGHT /
END PANEL
UPRIGHT /
END PANEL
GROOVE
FOR
PARTITION
BOTTOM OF UPRIGHT / END
PANEL - Indicated with double
holes
1
2
4
5
3

Position the plywood partition so that
the wood grain will be running vertically when
the unit is upright. Slightly bend the partition
and carefully slide it into the grooves that are
machined into the Upright panels. Once the
Partition has been completely pushed into the
groove, screw through the partition and into the
wood blocks (at an angle, see image). Repeat this
for both sides of the partition.
Starter and Adder Units are con-
nected with Intermediate Panels.
Intermediate Panels have holes on
both sides. Pass bolts with washers (as
pictured) through the bottom frame
blocks and intermediate panel. Repeat
the process with the top frames
Place shelf pins in the Upright panels as pic-
tured. (4) shelf pins are to be used per adjustable
shelf. Space the pins so that the ledges to hold the
shelves are all level.
Once all of the shelves are in the desired lo-
cations, use the 5/8” screws to fasten the shelves
in place. e 5/8” screws are screwed through
the underside of the shelf support and into the
underside of the shelf.
(48” H units shown)
Once the partition has been fas-
tened in place and all the Top and
Bottom frames have been aligned
correctly and wrench tightened,
stand the shelving unit upright.
7
6
9
10
8
5/8” Wood
Screw
bottom view (units shown upside down)
Plywood
Partition
Upright / End
Panel
Upright / End
Panel
Top Frame
Intermediate Panel
Bottom shelf
Bottom Frame
Adjustable Shelf
Plywood
Partition
Intermediate Panel
Bottom frame block
ADDER HARDWARE