
Set-Up
CLOCK - Setting the Clock:
1. Remove the cap from the bottle.
2. Press the MODE button once and the display will start to blink.
3. Use the DOWN or UP buttons to change the time.
4. When desired time is reached, press the MODE button once and the weekday indicator
will start to blink.
5. Use the DOWN or UP buttons to change the day of the week.
6. When desired weekday is reached press the MODE button once to store the settings and
return to the time display.
ALARM TIME(S) - Setting the Alarm Time(s):
1. Remove the cap from the bottle.
2. Press and hold the DOWN and UP buttons at the same time until the display blinks 12:--
PM.
3. Use the DOWN or UP buttons to reach the hour you wish an alarm to go off.
4. To set the alarm, press the CHECK button and an alarm symbol will appear in the upper
left corner.
5. Repeat steps 3 & 4 to set additional alarms.
6. To remove an alarm, go to the selected alarm hour and press the CHECK button and the
alarm symbol will disappear.
7. Press and hold the DOWN and UP buttons at the same time to store the settings and
return to the time display.
Reminder Time –How to use
NOTE: The display on your TimeCap will always record the time that the cap was last
opened to remind you of when you last took your medication, even if no alarms are set.
ALARM Beep - What to do when the ALARM goes OFF:
1. Remove the cap.
2. TAKE your MEDICATION.
3. Put the cap back on tightly until you hear a single ‘beep’
4. The time and day of week of when you last took your medication (and put the cap back
on) will automatically be recorded and displayed on the TimeCap.
5. If an alarm is overdue due to failure to take your medication the display will continue
blinking; showing the last time a dose was taken. This is to remind you of when you last took
your medication and the display will keep blinking until the TimeCap is opened and the
dose is taken.