RZE RESOLUTE SC User manual

RESOLUTE SC
Owner’s Manual

SETTING TIME ON WATCH
1
2
1Winding position
Rotate the crown counter-clockwise to release the
crown. The crown will “pop” out once fully unscrewed.
Rotate clockwise to wind the watch. Give the watch
20-30 winds to get it started.
2
A
Time position
Pull the crown at the second click position and rotate
the crown counter-clockwise to set the time.
SECURING THE CROWN
Push the crown back in only once. Keep the pressure
on the crown until you can feel the crown threads
catch. Turn clockwise to screw back in.
NOTE: There should be no resistances when screwing
down the crown. Should you feel any resistance in
screwing, please do not force it as it will ripe the
threads and void the warranty. Realign the screw
threads and try again with you feel resistance screwing
down the crown.
IMPORTANT NOTE
Do not over-wind the movement. Do not continue
winding after you feel resistance during manual
winding process.
- Unscrew crown then pull.
- Push and screw the crown
back in after setting time.
*Pop
28 28
A
- Unscrew crown then pull.
- Push and screw the crown
back in after setting time.
Rotating Bezel position
Unscrew the crown to allow the bezel to be rotated.
Feel a light click before screwing down to ensure the
gears are disengaged when you are setting the
rotating bezel.
Miyota 9-Series (9015/90S5)

GENERAL CARE INSTRUCTIONS
Ensure that the crown is fully screwed in before submerging in
water.
Do not attempt to open the caseback of the watch without
professional help or prior approval from RZE Watches.
Rinse the watch in fresh water after submerging in salt water.
Do not use soap to wash the canvas watch strap and air-dry the
strap after cleaning
Frequently asked questions
1. My watch is not moving when I receive it. What can I do?
Mechanical watches run based on the movements of your arm.
Give your watch a shake and wind using the crown to get the
watch moving again.
2. My watch is not keeping the power reserve of up to 40hrs, is
there something wrong?
Like a brand new car, you need to run in your brand new watch
movement for a few days before it start to perform to factory
standard. Wear/wind your watch regularly to ensure its always
moving.
3. My watch is not keeping time accurately (outside factory
tolerance of -10/+30sec/day)
Your watch may be magnetized. A watchmaker with a
demagnetizer will be able to fix the issue within minutes, for a
minimal fee.
4. Can I polish my watch?
Do not attempt to polish your watch. It will damage/remove the
UltraHex coating leaving you with raw titanium that oxidizes and
scratches easily.
For other enquiries, please contact
[email protected]
28 28