Sabrent TV-USBHD User manual

Sabrent TV-USBHD HYBRID USB HDTV TV TUNER WITH FM RADIO & REMOTE CONTROL
(ATSC DIGITAL/CLEAR QAM/NTSC ANALOG)
Driver Installation:
1. Connect your TV-USBHD dongle into an open USB 2.0 port on your computer.
2. Insert the software disc into your computer’s disc drive. When prompted, click on Run AUTORUN.EXE:
3. Click on Install Driver:
4. When prompted click on Install Driver:

5. Click OK:
6. Click on the Start Button. Type Device Manager into the search box, and click on Device Manager:
7. Click on the arrow to the left of the section labeled Sound, video and game controllers. Verify that the three
entries below appear, as shown below:

BlazeVideo HDTV Player Installation:
1. Click on Install Blaze HDTV Player:
2. Select your language, and click OK:
3. Click Next:

4. Click on I accept the agreement and click Next:
5. Click on Next:

6. Click on Install:
7. Click on Finish:

8. Click on the Start Button and open BlazeDTV 6.0:
9. Fill in the three sections shown below. Click Register:
10. When prompted, click OK:

11. Click on the Start Button and open BlazeDTV 6.0:
12. Click on the Open icon. Select your input source. Please note: ATSC should be selected for ATSC Digital TV and
Analog should be selected primarily for Cable TV.
13. Select your Video Source, and click OK:

14. Click OK:
15. Select your signal and your County or Region, and click OK:
16. Click the checkbox next to Close this dialog box… Wait for the scan to complete:

17. You can now watch your TV.

ArcSoft TotalMedia 3.5 Installation:
1. Insert the software disc into your computer’s disk drive. Explore the disc contents and run Setup.exe:
2. When prompted, click OK:
3. Click Next:

4. Click Yes:
5. Fill in the three sections shown below. Click Next:

6. Click Next:
7. Click Finish:

8. Click the Start Button. Open TotalMedia 3.5:
9. Click on TV:

10. Select your region, and click Next:
11. Select which Video Device you want to use. Click Next:

12. Select your Audio Device and click Next:
13. Select your TV Signal and click Next:

14. Click Start:
15. After the scan is complete, click OK:

16. You can configure a second tuner if you wish, otherwise click No, then Next.
17. Click Finish:

18. You can now watch your TV shows: