Saeco Incanto Deluxe User manual

Incanto Deluxe Quick Start Guide
Use these directions to get your machine up and running quickly.
Read the entire user manual, though, to thoroughly understand your new espresso machine.
Service Door Steam / Hot Water Wand
Drip Tray
Used Grounds Container
(Dregdrawer)
LCD Display
Coffee Bean Hopper
Parts of the Machine
Water Tank
Steam / Hot Water Dial
Power Button
Dispensing Head
Control Panel
DO NOT turn the machine on until water has been added to the water tank.
A Mavea Intenza water filter is included to improve the taste of your drinking water.
Please see the enclosed instructions for installing the water filter.
This machine has been inspected and tested. For this reason, you may find a small
amount of coffee grounds in your machine.
See reverse side to begin setting up your Saeco espresso machine.
Control Panel
(see detail)
Small Brew Button
Medium Brew Button Large Brew Button
Pre-ground Coffee Button
Descaling Button
Menu Button
Hot Water Button
Please Note

Setting Up the Machine
FFiillllWWaatteerrTTaannkk
··Remove water tank (Fig. 1) and fill with fresh drinking water.
··Replace water tank on back of machine.
FFiillllBBeeaannHHooppppeerr
··Open bean hopper lid and fill with whole espresso beans. (Fig. 2)
··Close bean hopper lid.
TTuurrnniinnggoonntthheeMMaacchhiinnee
··Plug the power cord into an outlet.
··Place container under the steam / hot water wand.
··Turn machine on by switching the power switch into the “On”
position.
(Located on the back of the machine, directly under the
water tank.)
··Machine will start automatically priming.
··Once complete, LCD display reads ‘Select Product - Ready for Use’,
BBrreewwEEsspprreessssoo
··Your machine is now ready to brew fresh, delicious espresso.
··Place a cup under dispensing head and press a brew button. (Fig. 3)
··
We recommend brewing approximately 5 espressos before drinking
to ensure the machine is dosing the full 7 gr. of ground coffee.
Contact Us
For more detailed instructions on how to operate the espresso machine, please refer to the user
manual. If further assistance is needed, please contact Saeco Consumer Care:
SSaaeeccooUUSSAA
call: 1-800-933-7876
email: [email protected]
visit: www.saeco-usa.com
SSaaeeccooCCaannaaddaa
call: 1-514-385-5551
email: [email protected]
visit: www.saeco.ca
TTooOOrrddeerrPPaarrttssaannddAAcccceessssoorriieess
visit: www.saecooutlet.com
Your machine may display a VENTILATE message on the LCD screen.
To clear this message, you will need to manually prime the machine by
performing the following steps:
··Turn the steam/hot water dial counter-clockwise. (Fig. 4)
··Allow water to flow from the steam/hot water wand for approximately
30 seconds.
··Turn the dial clockwise to stop the water flow and complete the
manual priming process.
··The LCD display will read ‘Select Product - Ready for Use’.
Ventilate Message
Figure 2
Figure 4
Figure 3