Safavieh Furniture FOX8208 User manual

180
Model# FOX8208
Product Dimensions:
L: 47.24"Wx23.62"Dx17.71"HS:
33.46"Wx18.89"Dx15.74"H
PIECEQUANTITY
A1X
DESCRIPTION PICTURE
Panel-1
B
leg-L
1X
Allen key
3X
12X
12X
12X
C
D
Panel-2
leg-S
1X
3X
HW1
HW2
HW4
HW3
Socket Screws 6x0.5X40MM
Split Lock washer 6mm
Flat washer 6mm
*Before beginning assembly of product, make sure all parts are present. Compare parts with part
contents list and hardware contents list.
*If any part is missing or damaged, do not attempt to assemble the product.
*Estimated Assembly Time: 30 minutes.
*Tools Required for Assembly (included): Allen Key
PREPARATION
CARE AND MAINTENANCE
NOTICE
*Please make sure that you have all parts indicated and they are in good condition before you begin
assembly of this item. Refer to part list and hardware list below for guidance.
*This item should be assembled on a soft surface to prevent scratching the finish during
assembly.
*This item may require periodic tightening.
*If you are having difficulty, our friendly Customer Care team is always here to help. Please
email [email protected]
Always use felt pads under all articles to prevent discoloration or softening of the lacquer. Plastic
and rubber bases on itcan discolor wood.Wipe up spills immediately and avoid common hazards
such as hot dishes, harsh solvents and abrasives. Cleaning should be donewith a soft lint free
cotton cloth dampened with water or furniture polish. On highly used surfaces we recommend
applying a quality pastewax which should be used on a regular basis to provide additional protection
from scratches and spills. How often you apply the wax depends onhow much wear the furniture
receives. Part List and Hardware List

*Before beginning assembly of product, make sure all parts are present. Compare parts with part contents list and hardware contents list.*If any part is
missing or damaged, do not attempt to assemble the product.
*Estimated Assembly Time: 30 minutes.
*Tools Required for Assembly (included): Allen Key
*If you are having difficulty, our friendly Customer Care team is always here to help. Please email [email protected]
PREPARATION
STEP1:
Attach leg-L(C) to panel-1(A) using Allen bolt (H1) Spring washer (H2) and flat
STEP2:
A ttach leg-S(D) to panel-2(B)using Allen bolt (H1) Spring washer (H2) and flat
H4
H1
H2
H3
H4
H1
H2
H3
washaer (H3),Tighten with allen key (H4)Stand table upright.Assembly is complete.
washaer (H3),Tighten with allen key (H4)Stand table upright.Assembly is complete.