Safavieh Lighting RALLEN CLF1012A User manual

CFL1012A ORB
ITEM#:CLF1012A
SIZE:φ52"X25.5-20.5"H
52-INCH CRYSTAL CEILING FAN
52-INCH CRYSTAL CEILING FAN

2
Safety Information
Pre-Installation
Hardware included
Celing
Hanging the Fan
Attaching the Fan Blades
Attaching the Lights
Install the crystal shade
Use of remote control
Care and cleaning
2
3
4
5
6
7
8
9
10
11

3
23.90lb
10.84kg 4.59cu.ft.
21.01lb
9.53kg

4
FF
GG
HH
II
JJ
FF Motor housing screw and lock washer(preassembled)
GG Light kit mounting screw(preassembled) 3
HH Light holder thumbscrew(preassembled) 4
II Plastic wire nut(not to scale) 3
JJ Pull chain and fob (not to scale) <hand pull chain only>

5

6

7
1.Fasten the Blade to the fan-motor assembly by
inserting the alignment post into the slot on the
bottom of the motor and tightening the pre-
installed Blade screws.
2.Repeat this step for the remaining blade
assemblies.
1.Fastening the blade to the motor
1. Remove the three screws from the light kit and
install them into the light pan.

8
RED Insert the line in the switching box of the motor into
the line of the light and tie insulated rubber tape.

S45 4W*3PCS
9
2.Please use on/off type"a" bulb max 25-watt or cfl bulb max
5-watt or led bulb max 5-watt, there is led 4-watt bulb in the box .
1.Select the appropriate bulb and install it on the lamp holder.
3.Hang the Glass lamp cover string on the lamp, and then put the
decorative pan in the bottom of the glass shade then screw
the decorative ball into the lamp.
Turn on the power and check the operation of the fan.The
remote controls the fan speed and light.
(hand pull chain only)
4. Connect the chain to the fan and the light switch.
(hand pull chain only)
If you reed to change the direction
of fan you need to remove the
lampshade and slide the switch
which on the lamp box
Glass lamp cover
Decorative ball
Decorative pan

10
Remote control wiring diagram